Module 0103-15 Introductions to hand tools fully solved graded A+

Module 0103-15 Introductions to hand toolsAnother name for a machinist's hammer is A. Ball-peen hammer B. Claw hammer C. Veneer hammer D. Sledgehammer A. Ball-peen hammer A heavy-duty tool used to drive posts or other large stakes is a A. Mallet B. Sledgehammer C. Bell-faced hammer D. Ball-peen hammer B. Sledgehammer The proper angle for the edges of a cold chisel is A. 90 degrees B. 60 degrees C. 45 degrees D. 30 degrees B. 60 degrees The type of screw is shaped like a square (see picture) a A. Phillips head B. Torx C. Allen D. Robertson D. Robertson Which of the following screws comes to a relatively sharp point at the base of its drive socket A. Reed and Prince B. Torx C. Allen D. Slotted A. Reed and prince How many sides does a hexagonal shape have A. four B. five C. six D. seven C. Six In what way is a spud wrench different from a pipe wrench? a. It is not adjustable. b. It has smooth jaws. c. It is significantly shorter. d. Using a handle extension is recommended. B. It has smooth jaws To quickly run a nut onto a bolt that resists spinning it on with the fingers, you can drive the socket with a A. Striking Wrench B. Open-end wrench C. Speed Handle D. Breaker bar C. Speed handle Another common name for lineman pliers is A. locking pliers B. Tongue-and-groove pliers C. Needle-nosed pliers D. Side cutters D. Side cutters Because of its stiffness, a folding rule is better than a cloth or steel tape for measuring A. vertical distance B. horizontal distance C. inside dimensions D. circular dimensions A. Vertical distance One situation that can make a measurement with a laser inaccurate is measuring to a