COMPEND TEST QUESTIONS NBE SCIENCES WITH CORRECT ANSWERS

COMPEND TEST QUESTIONS NBE
SCIENCES WITH CORRECT
ANSWERS

An Arterial Tube - Correct Answers -An instrument which is inserted into the artery for
the introduction of fluid is-

Groove Director - Correct Answers -An Instrument which may be used to guide an
arterial or vein tube into a vessel is the-

The proper embalming technique and Chemicals to use - Correct Answers -The
purpose of embalming analysis is to determine-

Intrinsic or Extrinsic - Correct Answers -Variable factors encountered with every dead
body are classified as -

Clean tissue pores , Retard Dehydration, Prevent Friction during massage (not Secure
Jaws in Position) - Correct Answers -Which of the following is a purpose of massage
cream?

Atmospheric Conditions - Correct Answers -Which of the following is an extrinsic factor
to be considered in embalming a dead body?

Chin Rest - Correct Answers -A device which extends from some point over sternum to
a point under the chin and is used to Support the Chin during Embalming.

Mandibular suture - Correct Answers -The method of mouth closure employing a suture
passed through the septum of the nose and around the mandible is called-

Lower one-third of the obit - Correct Answers -In normal eye closure the eyelids should
meet in the -

Sternoclavicular Articulation - Correct Answers -The Right Common carotid artery
begins at the level of the -

Superior border of the thyroid cartilage - Correct Answers -The common carotid arteries
terminate at the level of the -

Sternoclavicular Articulation to the anterior surface of the love of the ear - Correct
Answers -the linear guide for the common Carotid artery is the -

, Center of the auxiliary space parallel long axis of the upper extremity - Correct Answers
-The linear guide for the auxiliary artery is from the -

Anasarca - Correct Answers -Distention of the body tissues is a complication of -

1/2 (one half) - Correct Answers -when using gravity method of obtaining pressure for
injecting arterial fluid the embalmer can expect to receive approximately ____________
pounds of pressure per foot of elevation above the point of injection.

Set before opening the rate of flow - Correct Answers -When injecting a body with any
mechanical injector, the desired pressure should be -

restricted Cervical - Correct Answers -the process of injection and drainage in which
both common carotids are raised is referred to as -

Primary dilution - Correct Answers -when preparing to embalm a dead body the
embalmer will prepare a solution by adding the concentrated embalming fluid to water in
reservoir of the injection device, this dilution of fluid is called-

distribution - Correct Answers -the movement of embalming solutions from the point of
injection through the arteries arterioles capillaries venules and veins is called -

Pressure filtration - Correct Answers -the passing of arterial solution through the
capillary wall, caused by positive intravascular pressure is -

Alternate - Correct Answers -the method of drainage in relation to injection in which an
amount of arterial fluid is injected and then drainage is allowed to flow for a period of
time each one separately is the ____________ method.

Femoral Artery - Correct Answers -Which of the following blood vessels is the origin of
the popliteal artery?

Case analysis - Correct Answers -those pre-embalming considerations given to the
case at hand are called -

Tilted to the left 15 degrees - Correct Answers -During embalming the head should be -

Index - Correct Answers -the amount of HCHO (formaldehyde) measured in grams
dissolved in 100 ml. of water refers to -

Preservatives - Correct Answers -Chemicals which inactivate sapophytic bacteria and
alter tissues so as to render them less susceptible to decomposition are -

Dye - Correct Answers -a component of arterial fluids which imparts color to a solvent is
a-