ATPL intergraded Guides d'étude, Notes de cours & Résumés

ATP EXAM RESNA Assessment of Need questions with correct answers

State the airworthiness requirements for a helicopter used on air operations.(CAR 135) correct answer: (a) Each holder of an air operator certificate shall ensure that each aircraft it uses in conducting an air transport operation has a current standard category airworthiness certificate. (b) Each holder of an air operator certificate shall ensure that each aircraft it uses in conducting a commercial transport operation has- (1) a current standard category airworthiness certificate; or ...

ATPL navigation Question and answer rated A+ (2023)Formula to work radial error for INS/IRS radial error 3+3t nm Serviceability requirement errors for INR/IRS radial,cross track, along track 2nm/hour, +~20nm, +/- 25nm Maximum time operation for Single IRS/INS Ground alignment is not to exceed 10hrs 5hours or more another Nav system available Sole Tracking 3hours in CTA, 5hours in OCTA Maximum time operation for two or more IRS/INS Ground alignment is not to exceed 10...

ATPL AGK: Electrics Question and answer rated A+As an aircraft travels through the atmosphere, what charge does it gain? And what type of air will create more static to build up? negative dry air What static discharge systems do aircraft have and how do they work? Static dischargers/wicks - made of carbon fiber or cotton. Static builds up because it is a sharp point, and slowly discharges to atmosphere. Electrical bonding is flexible wire strips between aircraft components, all...

ATPL Flight planning Question and answer 100% solvedBlock Fuel Ramp Fuel Taxi fuel + APU fuel burnt + Take Off Fuel Take Off Fuel Block Fuel - Taxi fuel Trip Fuel Takeoff Climb to cruise level Flight in level cruise including any planned step climb or step descent Flight from the beginning of descent to the beginning of approach, Approach Landing at the destination Contingency Fuel 0.05 x Trip fuel Extra Fuel Commander's discretion Additional Fuel ...

EASA ATPL Principles of Flight | Flight Controls Question with complete solution 2023The effectiveness of a control depends upon - Distance from CG (moment) - Control surface area - Degree of deflection - IAS Aeroelasticity is ... the interaction between aerodynamic loads and elastic strain on the airframe, or whether a component bends or twists under the loads imposed by flight Elastic material vs plastic material Elastic: Following removal of load, structure returns to orig...

ATPL Flight Test Question with complete solution 2023What are the privileges of the licence? 1. An authorisation to conduct private and commercial operations under the VFR or IFR as PIC or Copilot. 2. Authorised to taxi an aircraft and operate a radio. What are the limitations on the exercise of privileges? IPC: - To exercise the privileges of a multi-crew pilot type rating, you must have a valid IPC for any multi-crew type-rating for an aircraft of the same category that was complete...

ATPL - PRINCIPLES OF FLIGHT Question and answer 20231. Which statement is true regarding the opposing forces acting on an aeroplane in steady-state level flight? a. Thrust is greater than drag and weight and lift are equal b. These forces are equal c. Thrust is greater than drag and lift is greater than weight d. Thrust is slightly greater than lift, but the drag and weight are equal b. These forces are equal 2. The stalling speed of an aeroplane is most affected by: a. Changes...

ATPL - AIRLAW ¼ Question with complete solution 20231. Except when cleared by an ATC unit, a VFR flight cannot enter or leave a Control Zone when the cloud base is lower than: a. 1000 feet and less than 8km visibility b. 2000 feet and less than 5km visibility c. 1500 feet or less than 5km visibility d. 1000 feet and less than 5km visibility c. 1500 feet or less than 5km visibility 2. What action should be taken when, during an IFR flight in VMC, you suffer a radio failure? a. R...

ATPL - Flight Performance and Planning Question with complete solution 2023What affects indicated stall speed? A. Weight, load factor, and power B. Load factor, angle of attack, and power C. Angle of attack, weight, and air density A. Weight, load factor, and power What is load factor? A. Lift multiplied by the total weight B. Lift subtracted from the total weight C. Lift divided by the total weight C. Lift divided by the total weight What is a characteristic of...