2024\2025 |ACCURATE ANSWERS |
SOLVED
Which duty is not the responsibility of a level I Inspector?
A) Handle citizen complaints related to fire and life safety.
B) Perform plans reviews.
C) Interpret and apply adopted codes and standards.
D) Determine occupancy loads for single-use buildings. - ACCURATE
ANSWERS✔✔ Perform plans reviews.
Most of the consensus standards that relate to fire and life safety are
developed by the following organizations except:
ASTM International,
National Fire Protection Assoc.,
American National Standards Institute,
Underwriters Laboratories - ACCURATE ANSWERS✔✔ American
National Standards Institute
Regarding Commercial Kitchen Hood Systems, pipe penetrations of the
exhaust hood require what?
a. Minimum 18 inch clearance to combustible materials
b. Printed manufacturer guidelines of spacing on the pipe itself
c. Gas shut off valve and electrical shunt accessibility
,d. A liquid tight continuous external weld - ACCURATE
ANSWERS✔✔ A liquid tight continuous external weld
A independent, non-profit organization that tests products for their
intended use and certifies them as safe describes:
A) ASTM International
B) American National Standards Institute
C) Underwriters Laboratories Inc.
D) Standards Council of Canada - ACCURATE ANSWERS✔✔
Underwriters Laboratories Inc.
Which is not one of the three general types of drawings used to show
structure, facility, or site information?
A. Plot plan
B. Aerial view
C. Floor plan
D. Elevation view - ACCURATE ANSWERS✔✔ Aerial view
Structural lumber has a moisture content of ___________% or less.
25%
19%
15%
12% - ACCURATE ANSWERS✔✔ 19%
, Which of the following occupancies does not fall under state and local
regulations?
A). Day care
B). Jail
C). Post office
D). Medical facility - ACCURATE ANSWERS✔✔ Post office
The typical life cycle of a model code edition is ___ years.
a. 5-7
b. 2-3
c. 7-10
d. 3-5 - ACCURATE ANSWERS✔✔ 3-5
For Dry systems exceeding 500 gallons, there must be a quick opening
device installed unless water is delivered to the system test connection
within a specific time frame. What is this time frame?
A. 30 seconds
B. 60 seconds
C. Not more than 30 seconds
D. Not more than 60 seconds - ACCURATE ANSWERS✔✔ Not more
than 60 seconds
Which of the following is an inspector not authorized to do?
A. Issue a summons.