OSHA Quizzes fully solved & updated

(1) During an OSHA inspection - answer-You have the right to talk to the inspector privately (1) When the employer receives an OSHA citation, it must be: - answer-Pasted for 3 days or until the violation is fixed (1) The creation of OSHA provided this important right to workers : - answer-The right to a safe and healthful workplace. (1) What type of OSHA inspection is conducted when immediate death or serious harm is likely? - answer-Imminent danger (1) A Safety Data Sheet (SDS) gives information about: - answer-Hazardous chemicals (1) The right of workers to seek safety and health on the job without fear of punishment is spelled out in: - answer-Section 11 (c) of the OSH Act. (1) If you fell that an OSHA inspection is needed to get hazards corrected at your workplace, which is your best option? - answer-Submit a written, signed complaint with specific hazard information. (1) OSHA requires that employers pay for most required personal protective equipment (PPE), including: - answer-Hard hats (1) The OSHA standards for Construction and General Industry are also known as: - answer-Part 1926 and Part 1910 (1) Among the right related to OSHA recordkeeping, workers have the right to review: - answer-The OSHA 300 Log and the OSHA 300A Summary (1) OSHA's mission is to: - answer-Protect the safety and health of America's workers (1) One of the main responsibilities employers have under OSHA is to: - answer-Provide training required by OSHA standards. (2) The leading cause of slips, trips, and falls is - answer-Contaminants on the walking surface (2) According to OSHA, ________ constitute the majority of general industry accidents - answer-Slips. trips, and falls (2) ___________ is likely to cause you to trip and fall - answer-Your foot striking an object in an unexpected way (2) Which of the following is not an example of hazard? - answer-Clean. dry floors surfaces (2) When left on the floor, which of these will create tripping hazards? - answer-Clutter, Cables, Extension cords, * CORRECT All of the above (2) Age, fatigue, inattentiveness, eyesight, and footwear are ______ that can contribute to slips, trips, and falls. - answer-Human factors (2) Whenever there is too little friction or traction between your shoes and the floor - answer-You may slip and fall (2) What should be placed near stairs, changes in elevation, and floor openings to prevent accidents and injuries? - answer-Visual cues (2) It is not safe to carry out work tasks on a walking surface that: - answer-Has inadequate lighting (2) Which of the following is most likely to cause a fall? - answer-Being too far off of your center of balance (3) An employer must have and maintain an employee alarm system that __________. - answer-is distinctive and recognized by all employees (3) What was the main factor that contributed to the loss of life in the Triangle Shirtwaist Factory tragedy? - answer-Locked stairwells doors (3) Which class of fire extinguisher would be best suited to put out a wood fire? - answer-Class A (3) The 3 parts of an exit route are the exit access, exit, and ________. - answer-Exit discharge (3) Which of the following is an example of an electricity hazard? - answer-Damaged extension cords (3) An exit sign must be: - answer-Illuminated by a reliable light source (3) Which of the following is not an example of a fire hazard? - answer-Obstructed exit door (3) An emergency action plan contains which of the following? - answer-Emergency evacuation procedures, Floor plans or maps showing escape routes Employee and employer responsibilities during an emergency * CORRECT: All of the above (3) An emergency response coordinator is responsible for all of the following, except: - answer-Attempting to put out a fire, no matter the size (3) Exit routes must be ______ and ___________. - answer-Free, unobstructed (4) Which is acceptable when using powered tools? - answer-Use double-insulated tools (4) Which is not an insulator? - answer-Copper (4) Conductor insulation must be approved for the _______ of use? - answer-Operating Temperature (4) Ground-fault circuit interrupters must be used for all of the following except? - answer-Any outdoor area (4) Which is a preventive measures to prevent hazards while working with power lines? - answer-Use only nonconductive tools and materials (4) Which of the following is not a category of electrical burns? - answer-Shock (4) What is grounding? - answer-Intentionally creating a low-resistance path that connects to the earth (4) Power cords can be damaged by which of the following? - answer-Door or window edges Staples Age *CORRECT All of the above (4) A/an __________ is a unit of measurement for electrical resistance. - answer-Ohm (4) Which of these is not a type of Ground Fault Circuit Adapter? - answer-Manual (5) Safety footwear must meet _______ minimum compression and impact performance standards. - answer-ANSI (5) Employer provided PPE training should include information about: - answer-How to maintain the PPE offered, How to use the PPE, Which type of PPE to use and how it should fit. * CORRECT All of the above (5) Which of the following guards against exposure to electrical hazards? - answer-Non-conductive footwear (5) For personal fall arrest systems all of the following apply except: - answer-Are not required to be paid for by employers (5) PPE is used when __________, ___________, and ____________ controls are not possible or do not provide suitable protection for workers. - answer-Engineering, work practice, and administrative (5) When a hard hat sustains an impact, it should: - answer-Be replaced (5) Employers should use data from the __________ when selecting appropriate PPE. - answer-Hazard assessment (5) Which of the following types of protection is an employer required to pay for? - answer-Hearing protection (5) Safety belts, lifelines, lanyards, and Personal Fall Arrest Systems are all examples of: - answer-Fall protection equipment (5) When using eye and face protection you should do all of the following except: - answer-Always remove contact lenses or glasses before use (6) The Hazard Communication Standard was modified to adopt the Globally Harmonized System to: - answer-Provide a standardized approach to hazard communication (6) Chemicals are classified as health hazards when they pose which of the following hazardous effects? - answer-Acute toxicity, Carcinogenicity, Respiratory sensitization * CORRECT All of the above (6) Employers should follow these three steps for putting a Hazard Communication program into practice: - answer-Identify responsible staff, identify hazardous chemical, and prepare and implement the program. (6) Sections __________ of the Safety Data Sheet (SDS) contains general information about the chemical, identification, hazards, composition, safe handling practice, and emergency control measures. - answer-1 through 8 (6) Hazard Communication covers both __________ and health hazard. - answer-Physical (6) If a chemical manufactures, importer, or employer becomes aware of any significant information regarding the hazard of a chemical or ways to protect against hazards, this new information must be added to the SDS within __________ months. - answer-Three (6) Chemicals in the _________ class are liquids which, even in small quantities, are liable to ignite within five minutes after coming into contact with air. - answer-Pyrophoric Liquid (6) The _______ pictogram is used to warn about the oxidizer class of chemical hazards. - answer-Flame over Circle (6) Which of the following is the general definition of Hazard Communication? - answer-Hazard Communication is all about identifying chemical hazards in the workplace and communicating these hazards to ensure a safe and healthy work environment. (6) All container of hazardous chemicals leaving the workplace must be labeled, tagged, or marked with the following information except? - answer-Name, address, and telephone number of employees using chemical at worksite. (7) Which of the following openings does not require guardrails? - answer-Temporary floor openings (7) Around 20 to 25 percent of forklift- related injuries were related to ______________. - answer-Inadequate training (7) Which of the following is manual material handling? - answer-Carrying a heavy tool (7) Which of the following is not an example of rigging equipment? - answer-Crane (7) Make sure to Keep ____________ clear of obstruction to prevent workers injuries and damages materials - answer-Aisles and passageways (7) The critical parts of a crane, such as operating mechanisms and system components, must be inspected ____________ for any issues or damage. - answer-Daily (7) Rigging equipment should be proof tested _________ use to ensure it can handle the loads it will be used for. - answer-Before (7) Which of the following is mechanical material handling? - answer-Lifting something with a crane. (7) Which of the following motions is commonly cited as a cause for back injuries? - answer-Bending, Pushing, Lifting, *CORRECT All of the above (7) Which of the following is not a method of securing stacked materials? - answer-Leave mails in when stacking wood (8) Which of the following is an exception to the general rule for safeguarding to prevent hazards during servicing and maintenance of machines? - answer-Servicing or maintenance is not hazardous for employees Maintenance is minimal and performed as an important part of production Employer uses other safeguards which provide effective protection as required by OSHA standards * CORRECT All of the above. (8) Which of the following is a description of a pullback device? - answer-Device that uses cable attached to hands which allows access to the point of operation when the slide/ram is up and automatically withdraws hands when the slide/ram begins to descend. (8) Which of the following types of machines guard is generally preferred because of its simplicity and durability? - answer-Fixed (8) Any part of a machine which _____________ while in operation can cause a hazard. - answer-Moves (8) The following are all machine safeguarding requirements except: - answer-Must prevent workers from lubricating a machine without removing the safeguard (8) Which of the following is not a common type of hazardous mechanical motion? - answer-Shearing (8) Which of the following is a function of a safety device? - answer-Stopping the machine if any part of the body is accidentally placed in the danger area. Requiring the worker to use both hands on machine controls which keeps them out of the danger area Restraining or removing the operator's hands from the danger area *CORRECT All of the above (8) Which of the following is the definition of point of operation? - answer-Area in a machine where the work is performed (8) Which of the following is a type of machine safeguarding? - answer-Feeding and ejection methods (8) Which of the following should employers prevent in order to ensure the safety and health of workers in regards to machine guarding? - answer-Allowing workers to use a machine without training (9) Which of the following is not an example pf appropriate PPE? - answer-Prescription glasses (9) Which of the following presents a sharps hazard? - answer-Uncapped syringe (9) Which of the following is an example of an engineering control? - answer-Using self re-sheathing needles (9) A method of infection control where all human blood and potentially infectious materials are handled as if they are known to be infectious, regardless of whether they are believed to be infected or not, is called - answer-universal precautions (9) What are bloodborne pathogens? - answer-Infectious microorganisms present in human blood (9) Which of the following is the best method of preventing Hepatitis B? - answer-Vaccination (9) When must Exposure Control Plans be update? - answer-Whenever necessary to include modified tasks and procedures Whenever necessary to reflect new or revised employee positions that involve occupational exposure Annually *CORRECT All of the above (9) Contaminated sharps must be disposed of in _______________. - answer-closeable, labeled, leak-proof containers built to properly contain all contents (9) Which of the following is not a possible method of transmission for Hepatitis B, Hepatitis C, or HIV? - answer-Blood splash on properly secured PPE (9) Which of the following has a vaccine? - answer-Hepatitis B