Rigging 1 question n answers graded A+ 2024/2025

Rigging 1 question n answers graded A+ 2024/2025List the three elements of safe rigging practices discussed in this program. - correct answer Planning job, inspecting equipment, using the equipment properly. T or F: When planning a job where the actual weight of the load cannot be accurately determined, it is best to over-rig the job for safety. - correct answer True Equipment manufacturers often design _____________________ into equipment to make it easy to raise or lower the equipment. - correct answer lifting points When inspecting a rope you should look for: - correct answer damage, wear, frays, breaks, bends, kinks, burns, and melting. Fiber rope made of manila, sisal, or cotton is generally classified as ________________ fiber rope. - correct answer Natural List four characteristics of the finer rope typically used for rigging: - correct answer Load strength, flexibility, resistance to mildew, and chemicals. T or F: Any bend in a rope that causes the standing part and the running end to cross over each other is called a bight. - correct answer True A knot commonly used to attach slings to poles and to join two ropes of the same diameter together is called a ________________ knot. - correct answer square When trying an overhand slip knot: - correct answer Make a bight, make a loop in one side, then bring the bight through the loop. Square knots, slip knots, and half hitches are primarily used on ___________________ loads. - correct answer light