The correct method of stating 4,500 feet MSL to ATC is... - Correct Answer ✔️
✔️"FOUR THOUSAND FIVE HUNDRED."
The correct method of stating 10,500 feet MSL to ATC is... - Correct Answer ✔
️✔️"ONE ZERO THOUSAND, FIVE HUNDRED."
When an air traffic controller issues radar traffic information in relation to the 12-
hour clock, the reference the controller uses is the aircraft's... - Correct Answer
✔️✔️Ground track.
An ATC radar facility issues the following advisory to a pilot flying on a heading of
090*: "TRAFFIC 3 O'CLOCK, 2 MILES, WESTBOUND..." Where should the pilot look
for this traffic? - Correct Answer ✔️✔️South.
An ATC radar facility issues the following advisory to a pilot flying on a heading of
360*: "TRAFFIC 10 O'CLOCK, 2 MILES, SOUTHBOUND..." Where should the pilot
look for this traffic? - Correct Answer ✔️✔️Northwest.
An ATC radar facility issues the following advisory to a pilot during a local flight:
"TRAFFIC 2 O'CLOCK, 5 MILES, NORTHBOUND..." Where should the pilot look for
,this traffic? - Correct Answer ✔️✔️Between directly ahead and 90º to the
right.
While on final approach for landing, an alternating green and red followed by a
flashing red light is received from the control tower. Under these circumstances
the pilot should... - Correct Answer ✔️✔️Exercise extreme caution and
abandon the approach, realizing the airport is unsafe for landing.
A steady green light signal directed from the control tower to an aircraft in flight
is a signal that the pilot... - Correct Answer ✔️✔️Is clear to land.
A flashing white light from the control tower to a taxiing aircraft is an indication to
- Correct Answer ✔️✔️Return to the starting point on the airport.
If the control tower uses a light signal to direct a pilot to give way to other aircraft
and continue circling the light will be... - Correct Answer ✔️✔️Steady red.
An alternating red and green light signal directed from the control tower to an
aircraft in flight is a signal to... - Correct Answer ✔️✔️Exercise extreme
caution.
,If the aircraft's radio fails, what is the recommended procedure when landing at a
controlled airport? - Correct Answer ✔️✔️Observe the traffic flow, enter
the pattern, and look for a light signal from the tower.
When activated, an emergency locator transmitter (ELT) transmits on... - Correct
Answer ✔️✔️121.5 &243 MHz.
Which procedure is the recommended to ensure that the emergency locator
transmitter (ELT) has not been activated? - Correct Answer ✔️✔️Monitor
121.5 before engine shutdown.
The letters VHF/DF appearing in the Airport/Facility Directory for a certain airport
indicate that... - Correct Answer ✔️✔️The Flight Service Station has
equipment with which to determine your direction from the station.
To use VHF/DF facilities for assistance in locating an aircraft's position, an aircraft
must have a... - Correct Answer ✔️✔️VHF transmitter and receiver.
Who should not participate in the Land and Hold Short Operations (LAHSO)
program? - Correct Answer ✔️✔️Student pilots.
Who has final authority to accept or decline any land and hold short clearance? -
Correct Answer ✔️✔️Pilot in command.
, When should pilots decline a land and hold short clearance? - Correct Answer
✔️✔️When it will compromise safety.
Where is the "Available Landing Distance" (ADL) data published for an airport that
utilizes Land and Hold Short Operations - Correct Answer ✔️✔️Special
Notices section of the Airport/Facility Directory (AF/D).
What is the minimum visibility for a pilot to receive a land and hold short
clearance? - Correct Answer ✔️✔️3 SM.
With respect to the certification of airmen, which is a category of aircraft?
A. Gyroplane, helicopter, airship, free balloon
B. Airplane, rotorcraft, glider, lighter-than-air
C. Single-engine land and sea, multiengine land and see - Correct Answer ✔️
✔️B. Airplane rotorcraft, glider, lighter-than-air.
With respect to the certification of airmen, which is a class of aircraft?
A. Airplane, rotorcraft, glider, lighter-than-air
B. Single-engine land and sea, multiengine land and sea