ASE CERTIFICATION EXAM | QUESTIONS AND ANSWERS | 100% CORRECT ANSWERS |
LATEST EXAM
Spark plugs are being replaced on a v6 engine. Which of the following should
be performed before removing the boot? - CORRECT ANSWER -☑☑Twist
the boot 1/2 a turn
Technician A days that a positive crankcase ventilation (pvc) system reduces
vehicle emissions. Tech B says that a pvc system helps increase crankcase
pressure. Who is correct? - CORRECT ANSWER -☑☑Tech A
Tech A says that secondary ignition wires should be inspected when replacing
spark plugs. Tech B says that if a new spark plug is dropped it can be used as
long as the gap doesn't change. Who is correct? - CORRECT ANSWER -
☑☑Tech A
Incorrect valve timing could be caused by... - CORRECT ANSWER -
☑☑Incorrect timing belt position
When measuring parallelism of a disc brake rotor, A technician measures 0.002"
variation beyond the specification. The next step is to? - CORRECT
ANSWER -☑☑Determine the minimum rotor machine to thickness
Tech A says that disconnecting the negative battery cable may be required to
disable the air bag system. Tech B says that a self powered test light can be used
to test air bag system components. Who is correct? - CORRECT ANSWER -
☑☑Tech A only
A vehicles battery prematurely fails. A charging system output test shows the
alternator is producing a constant 16.0 volts. This could indicate a failed... -
CORRECT ANSWER -☑☑Voltage regulator
, A dirty cabin air filter can cause... - CORRECT ANSWER -☑☑A musty
smelling cabin
Define the term stroke - CORRECT ANSWER -☑☑Distance the piston
travels from TDC (top dead center) to BDC (bottom dead center)
A vehicle is being checked for power steering leaks Technician A says that leaks
can develop in the fitting hoses and seals, Technician B says that the steering
components should be observed for leaks while a helper turns the steering wheel
from side to side. Who is right? - CORRECT ANSWER -☑☑Both
Brake fluid must meet minimum standards set by... - CORRECT ANSWER -
☑☑Department of traffic (DOT)
A flexible rubber brake line is being inspected.
Technician A says small blisters in the rubber are acceptable if they are not
leaking.
Technician B says that small cracks in the rubber require replacement of the
hose.
Who is correct? - CORRECT ANSWER -☑☑Technician B only
A technician is preforming a service on a vehicle there is a risk of splashing
liquid. Technician A says that regular safety glasses with side shields will work.
Tech B says that goggles combined with a face shield will provide adequate
protection. Who is correct? - CORRECT ANSWER -☑☑Tech B
A band type TPMS (tire pressure monitor system) is being installed in the center
of the rim. How many degrees form the valve stem should the sensor be
mounted? - CORRECT ANSWER -☑☑180 (sensor and valve stem should be
parallel with each other)
LATEST EXAM
Spark plugs are being replaced on a v6 engine. Which of the following should
be performed before removing the boot? - CORRECT ANSWER -☑☑Twist
the boot 1/2 a turn
Technician A days that a positive crankcase ventilation (pvc) system reduces
vehicle emissions. Tech B says that a pvc system helps increase crankcase
pressure. Who is correct? - CORRECT ANSWER -☑☑Tech A
Tech A says that secondary ignition wires should be inspected when replacing
spark plugs. Tech B says that if a new spark plug is dropped it can be used as
long as the gap doesn't change. Who is correct? - CORRECT ANSWER -
☑☑Tech A
Incorrect valve timing could be caused by... - CORRECT ANSWER -
☑☑Incorrect timing belt position
When measuring parallelism of a disc brake rotor, A technician measures 0.002"
variation beyond the specification. The next step is to? - CORRECT
ANSWER -☑☑Determine the minimum rotor machine to thickness
Tech A says that disconnecting the negative battery cable may be required to
disable the air bag system. Tech B says that a self powered test light can be used
to test air bag system components. Who is correct? - CORRECT ANSWER -
☑☑Tech A only
A vehicles battery prematurely fails. A charging system output test shows the
alternator is producing a constant 16.0 volts. This could indicate a failed... -
CORRECT ANSWER -☑☑Voltage regulator
, A dirty cabin air filter can cause... - CORRECT ANSWER -☑☑A musty
smelling cabin
Define the term stroke - CORRECT ANSWER -☑☑Distance the piston
travels from TDC (top dead center) to BDC (bottom dead center)
A vehicle is being checked for power steering leaks Technician A says that leaks
can develop in the fitting hoses and seals, Technician B says that the steering
components should be observed for leaks while a helper turns the steering wheel
from side to side. Who is right? - CORRECT ANSWER -☑☑Both
Brake fluid must meet minimum standards set by... - CORRECT ANSWER -
☑☑Department of traffic (DOT)
A flexible rubber brake line is being inspected.
Technician A says small blisters in the rubber are acceptable if they are not
leaking.
Technician B says that small cracks in the rubber require replacement of the
hose.
Who is correct? - CORRECT ANSWER -☑☑Technician B only
A technician is preforming a service on a vehicle there is a risk of splashing
liquid. Technician A says that regular safety glasses with side shields will work.
Tech B says that goggles combined with a face shield will provide adequate
protection. Who is correct? - CORRECT ANSWER -☑☑Tech B
A band type TPMS (tire pressure monitor system) is being installed in the center
of the rim. How many degrees form the valve stem should the sensor be
mounted? - CORRECT ANSWER -☑☑180 (sensor and valve stem should be
parallel with each other)
