And Answers Verified 100% Correct
The connection of vent risers aboveground to form a single vent opening is called
a ____?
a. manifold
b. flow limiter
c. pressure regulator
d. pressure vac-vent - ANSWER -a. manifold
When installing a Healy VP-1000 Vac-Motor the technician should do all
EXCEPT ____
a. replace the nozzle
b. wear eye protection
c. properly barricade the area
d. turn off power to the dispenser - ANSWER -a. replace the nozzle
In the Healy EVR Phase II system, the VP-1000 pumps run at full speed only
when ____?
a. the nozzles on both side of the dispensers are picked up and not authorized
b. the nozzle on one side is picked and authorized
c. nozzles on both sides are picked up and authorized
d. the dispensers on both side are authorized but the nozzles are not dispensing gas
- ANSWER -c. nozzles on both sides are picked up and authorized
Per EO VR-101-E, the P/V vent cap shall be allowed to ____ ft-lbs
a. 10-20
b. 20-50
c. 50-75
, d. 75-100 - ANSWER -b. 20-50
In regards to the Healy Phase II EVR System, when the power to the dispenser is
on but no nozzles authorized, the VP-1000 motors will run ____?
a. for a cycle every 10 minutes
b. when the V/L is out of range
c. when the ambient temperature is below 40 degrees F
d. when the pressure of the underground tank exceeds 2 inches WC - ANSWER -c.
when the ambient temperature is below 40 degrees F
According to E0 VR-201-A, after installing a new spout assembly in the Healy
900 nozzle, the following test must be conducted,
a. V/L
b. nozzle bag test
c. dispenser leak decay test
d. nozzle dispensing shut-off test - ANSWER -d. nozzle dispensing shut-off test
According to CP-201, condensate traps shall meet the following requirements
EXCEPT:
a. CARB certified
b. capable of automatic evacuation of liquid
c. installed at least below the UST tank level
d. equipped with an alarm system in case of failure of the evacuation system -
ANSWER -c. installed at least below the UST tank level
The minimum internal diameter the underground vapor recovery line after the first
manifold and before the tank is ____ inches.
a. 1 1/2"
b. 2"
c. 3"
d. 4" - ANSWER -c. 3"