And Answers Verified 100% Correct
In the PEI #300 manual, pressure decay, dynamic back pressure, and A/L testing
satisfy who's testing requirements?
A. CARB
B. water resources
C. environmental health
D. fire department - ANSWER -A. CARB
When removing liquid from a sump or spill bucket and the liquid contains fuel, it
must ____?
A. be managed as hazardous waste
B. pumped into a bucket to evaporate
C. scooped or bailed onto the concrete pad to evaporate
D. put into a sealed container, then put into the trash container - ANSWER -A. be
managed as hazardous waste
Before working on any electrical circuits always de-energize and use
A. NFPA
B. OSHA
C. ICC
D. UBC - ANSWER -A. NFPA
The two point Phase I vapor recovery system requires that a separate vapor
recovery riser pipe be installed in the tank and be equipped with a ____?
A. drop-tube
B. locking block valve
C. P/V vent
D. vapor recovery adaptor - ANSWER -D. vapor recovery adaptor
, The term "hanging hardware" refers to...
A. nozzle, hose breakaway
B. vent cap, nozzle, swivel
C. shear valve, UDC, hose
D. sump sensor, vapor valve, nozzle - ANSWER -A. nozzle, hose breakaway
A valve installed in a motor-vehicle fueling hose designed to separate with little or
no product spillage when excessive pulling force is placed on the hose is called
____?
A. breakaway
B. hose clamp
C. shear valve
D. flow limiter - ANSWER -A. breakaway
In the PEI #500 manual, a Level II Qualified Person can do all EXCEPT:
a. open cabinet doors
b. reconnect breakaways
c. measure nozzle flow rates
d. repair or replace dispenser components - ANSWER -d. repair or replace
dispenser components
A Gilbarco Vapor-Vac, OPW Vapor Saver system is considered to have a vapor
recovery equipment defect (VERD) if the vapor escape guard on an OPW 12-VW
nozzle is missing or damaged on at least ____% of the circumference of the
device?
a. 25
b. 50
c. 75
d. 100 - ANSWER -c. 75