Pipefitter NCCER Test | Already Graded 100% Pass| Newest !

Pipefitter NCCER Test | Already Graded 100% Pass| Newest ! Convert 1/4 to its decimal equivalent. A) .01 B) .25 C) 0.4 D) 0.5 B Piping that is field-routed to a pump must be supported A) Off the pump suction B) Diagonally C) Independently D) Off the pump discharge C What is used when lighting a cutting torch ? A) Striker B) Cigarette lighter C) Match D) Any open flame A Where is specific information needed to install piping and associated items found ? A) Reliability network B) Owner of the company C) Material Manufacturer D) Standards and Specifications D Damaged and broken tools should be A) Used if possible B) Kept for backup C) Taken out of Service D) Used for minor tasks C What is the ID of 10'' schedule 80 piping. A) 9 3/16 B) 9 5/16 C) 9 9/16 D) 10 1/16 C The two steps in making up threaded joints are the hand engagement and A) Machine makeup B) Wrench makeup C) Driver makeup B Which of the following actions should be taken before a hydrostatic test is performed ? A) Remove pressure relief valves B) Leave control mechanisms in place C) Leave orifice flanges in place D) Remove blinds a A 4-inch lateral riser is to be fabricated for a 6-inch pipe. How many ordinate lines will be needed to lay out this cut ? A) 32 B) 16 C) 8 D) 4 C Who is qualified to repair power tools. A) Journey person B) Competent Technician C) Electrician D) Tool crib attendant B Which of the following plastic pipes is NOT joined by solvent welding ? A) PVC B) HDPE C) CPVC D) ABS B Material placed in the bottom of the trench under the pipe to provide support is called.