Bolting Test #1 Save
Practice questions for this set
Learn 1 /7 Study using Learn
The statement of special inspection
Give this one a go later!
1 The special inspector shall furnish daily inspection reports to the _________ and ________
2 A bolt calibration device is required for pre-installation testing whenever......
The type and extent of each special inspection shall be located in ________
, According to the Specifications for Structural Joints, where twist-off tension control bolts are
4
used, what field inspection is of primary importance for joint strength?
Press any key to continue Don't know? Continue
Terms in this set (37)
According to the AISC Steel 1- 13/16
Construction Manual, the
recommended maximum size of
anchor-rod hole in a base plate
for a 1-inch diameter anchor-rod
is _____ inches
According to the Specification • Calibrated wrench pretensioning
for Structural Joints, for • Oversized or slotted hole in the outer-ply of the connection
Pretensioned and slip critical • Twist off type tension control bolt
joints, which of the following
conditions require washers in the
high strength bolted connection?
According to the Specification 3
for Structural Joints, not fewer
than ______ complete fastener
assemblies of each combination
of diameter, length, and grade
are to be checked at the job site
in the tension calibrator
According to the Specification Checking the condition of faying surfaces
for Structural Joints, what
additional inspection is required
for a slip critical joints?
Practice questions for this set
Learn 1 /7 Study using Learn
The statement of special inspection
Give this one a go later!
1 The special inspector shall furnish daily inspection reports to the _________ and ________
2 A bolt calibration device is required for pre-installation testing whenever......
The type and extent of each special inspection shall be located in ________
, According to the Specifications for Structural Joints, where twist-off tension control bolts are
4
used, what field inspection is of primary importance for joint strength?
Press any key to continue Don't know? Continue
Terms in this set (37)
According to the AISC Steel 1- 13/16
Construction Manual, the
recommended maximum size of
anchor-rod hole in a base plate
for a 1-inch diameter anchor-rod
is _____ inches
According to the Specification • Calibrated wrench pretensioning
for Structural Joints, for • Oversized or slotted hole in the outer-ply of the connection
Pretensioned and slip critical • Twist off type tension control bolt
joints, which of the following
conditions require washers in the
high strength bolted connection?
According to the Specification 3
for Structural Joints, not fewer
than ______ complete fastener
assemblies of each combination
of diameter, length, and grade
are to be checked at the job site
in the tension calibrator
According to the Specification Checking the condition of faying surfaces
for Structural Joints, what
additional inspection is required
for a slip critical joints?
