NCCCO Tower Crane / NCCCO Core Exams ( 2025
UPDATES STUDY BUNDLE WITH COMPLETE SOLUTIONS)
Questions and 100% Correct Verified Answers | Grade
A
Splices in rall tracks shall have .....ANSWER.....Smooth Joints
Hydraulic systems should have their proper fluid level checked
.....ANSWER.....Daily
If power fails during operations, the following shouldn't apply
.....ANSWER.....Do your best to finish moving load where it was
designated to go
If load is undetermined who is to find out if load weight does not
exceed crane rating at radius at which the load is to be lifted
.....ANSWER.....Person responsible for lift
Where should climbing instructions be kept .....ANSWER.....ON
Site
,Page 2 of 39
All climbing operations shall be performed under the supervision
of .....ANSWER.....Qualified person
When cranes are erected, load limiting devices shall be tested
for proper setting and operation .....ANSWER.....Before crane is
placed in service
Hooks shall be equipped with latches unless the application
makes the use of the latch .....ANSWER.....Impractical
Size and position of signs or panels must satisfy the limitations of
.....ANSWER.....Manufacturer
Fall prevention measures are needed for working at locations
where you are exposed .....ANSWER.....To a fall of 6ft or more
Travel distance on hand levers shall not be greater
.....ANSWER.....than 14 inches from neutral position
For power lines rated 175KV the minimum clearance between
the lines and any part of the crane or load is .....ANSWER.....15ft
,Page 3 of 39
All controls shall be tested by the operator at the
.....ANSWER.....start of new shift
Before each climbing operation all load members of the support
system shall be .....ANSWER.....Inspected
Chain slings are required to be .....ANSWER.....ID tagged
Welding on loads suspended by the crane can only be done if
the load has .....ANSWER.....Insulated slings
How much does an average cubic yard of concrete weight
.....ANSWER.....4,000 lbs
Main power switch for tower crane is .....ANSWER.....At base of
crane
Items not listed in the frequent inspection checklist are
.....ANSWER.....Hydraulic pumps and valves for excessive wear or
damage
, Page 4 of 39
When is it necessary to determine that there is no practical
alternative way to perform the needed work or to gain access to
the area .....ANSWER.....Personnel Lift
Each series of voice signals shall contain three elements stated in
the following order .....ANSWER.....Function and Direction -
Distance and speed - Function stop
When lifting personnel communication shall be maintained
between three of the next four .....ANSWER.....Person(s) being
lifted - Operator - Signal person
The condition when the tower load block or hook assembly comes
in contact with the upper .....ANSWER.....Two-blocking
Load bearing members of the climbing and support system shall
be inspected before each .....ANSWER.....Climbing operation
Where shall a wind velocity indicating device be mounted
.....ANSWER.....At or near the top of crane