IICRC WRT 2025/2026
___________ pressure is the force exerted by water or gas on the surrounding
environment. - ANS Vapor
_______________ dehumidifiers are the most common utilized in restoration. -
ANS Refrigerant
"cide" means to _______ - ANS Kill
"stat" means to _______ or ________ - ANS Limit or control
A balanced drying is when the rate of dehumidification is equal to or greater than the
rate of ___________________. - ANS Evaporation
A building material used in construction that basically resists moisture is
_____________. - ANS Plywood
A critical first step in using biocides/disinfectants is to
____________________________ - ANS Read and Follow the Label
instructions
A gallon weighs ______lbs. (______kg) - ANS 8.34lbs
A General Contractors license, appropriate _________ license and General Liability
insurance may be required in your market areas. Be Aware! - ANS Business
A requirement for an insurance ______________ (deposit) should be clearly
explained over the phone before you respond. - ANS Deductible
A standard refrigerant dehumidifier requires a minimum temperature of ______. -
ANS 68°F
Accurate written _____________ must begin when the first contact is made with the
company. - ANS Records
After arriving on the loss, it is important to identify and __________ potential safety
hazards. - ANS Eliminate
All electrical plug adapters must be ___________. - ANS GFI
All individuals who will be wearing respirators must be medically cleared, ______
tested, and trained to don/ ______ the respirator and safety equipment. - ANS
Fit tested and don/doff
, IICRC WRT 2025/2026
Always dispose of extracted water back into the ___________ system. - ANS
Sanitary
An agent that kills or inactivates viruses is: _________________ - ANS
Virucide
As moisture evaporates from a surface, the temperature of that surface becomes
____________. - ANS Cooler
As the humidity increases, hygroscopic materials take on more moisture i.e., water
vapor, from the air until they reach _______________ with the environment. -
ANS Equilibrium
At what point does condensation occur at a condition of 750F (240C) at 60% RH?
______ - ANS 60 degrees faranhieght
Before spraying any chemical, in an occupied structure, find out if anyone has any
_________________ sensitivities. - ANS Respiratory
Blowing air directly on visible mold will__________________________ - ANS
Aerosolize/ contaminate the area
Blown cellulosic insulation, when wet, tends to pack _______ and lose its R value. -
ANS Pack down
Books and paper that are saturated with clean water must be _________ or dried
within ______ hours. - ANS Frozen or dried within 24 hours
Can the tool in #2 tell us which layer is wet? Yes or No - ANS No
Carpet ___________ is always replaced in Category "2" & "3" losses if wet. -
ANS Pads
Carpet cleaning, if saved, is required due to tracked and _________ soil. - ANS
Wicked
Carpet delamination is the separation of the __________ backing and __________
backings of tufted carpet. - ANS Primary and secondary
Ceilings, which are sagging with excessive moisture should be first _________ and
then ___________ to help speed the drying. - ANS Drained and removed
___________ pressure is the force exerted by water or gas on the surrounding
environment. - ANS Vapor
_______________ dehumidifiers are the most common utilized in restoration. -
ANS Refrigerant
"cide" means to _______ - ANS Kill
"stat" means to _______ or ________ - ANS Limit or control
A balanced drying is when the rate of dehumidification is equal to or greater than the
rate of ___________________. - ANS Evaporation
A building material used in construction that basically resists moisture is
_____________. - ANS Plywood
A critical first step in using biocides/disinfectants is to
____________________________ - ANS Read and Follow the Label
instructions
A gallon weighs ______lbs. (______kg) - ANS 8.34lbs
A General Contractors license, appropriate _________ license and General Liability
insurance may be required in your market areas. Be Aware! - ANS Business
A requirement for an insurance ______________ (deposit) should be clearly
explained over the phone before you respond. - ANS Deductible
A standard refrigerant dehumidifier requires a minimum temperature of ______. -
ANS 68°F
Accurate written _____________ must begin when the first contact is made with the
company. - ANS Records
After arriving on the loss, it is important to identify and __________ potential safety
hazards. - ANS Eliminate
All electrical plug adapters must be ___________. - ANS GFI
All individuals who will be wearing respirators must be medically cleared, ______
tested, and trained to don/ ______ the respirator and safety equipment. - ANS
Fit tested and don/doff
, IICRC WRT 2025/2026
Always dispose of extracted water back into the ___________ system. - ANS
Sanitary
An agent that kills or inactivates viruses is: _________________ - ANS
Virucide
As moisture evaporates from a surface, the temperature of that surface becomes
____________. - ANS Cooler
As the humidity increases, hygroscopic materials take on more moisture i.e., water
vapor, from the air until they reach _______________ with the environment. -
ANS Equilibrium
At what point does condensation occur at a condition of 750F (240C) at 60% RH?
______ - ANS 60 degrees faranhieght
Before spraying any chemical, in an occupied structure, find out if anyone has any
_________________ sensitivities. - ANS Respiratory
Blowing air directly on visible mold will__________________________ - ANS
Aerosolize/ contaminate the area
Blown cellulosic insulation, when wet, tends to pack _______ and lose its R value. -
ANS Pack down
Books and paper that are saturated with clean water must be _________ or dried
within ______ hours. - ANS Frozen or dried within 24 hours
Can the tool in #2 tell us which layer is wet? Yes or No - ANS No
Carpet ___________ is always replaced in Category "2" & "3" losses if wet. -
ANS Pads
Carpet cleaning, if saved, is required due to tracked and _________ soil. - ANS
Wicked
Carpet delamination is the separation of the __________ backing and __________
backings of tufted carpet. - ANS Primary and secondary
Ceilings, which are sagging with excessive moisture should be first _________ and
then ___________ to help speed the drying. - ANS Drained and removed
