HIC Exam Questions And Answers

Nailing into hard wood, whats best to use ? - ANS Cut na To avoid hardening due to hydration ....use masonry mo before? - ANS 2 1/2 Hours Heat flows in what direction ? - ANS Hot to Cold First and most important step in using or preparing a material ? - ANS Thoroughly read and understand the manufactures directions . whats true abou the gypsum broads over wood framing ? - ANS Apply First to ceiling , then to wall What is used to remove air pockets from place concrete ? - ANS Vibration wide square-edged boards are to be used for broad and batt siding . how should the batten strips be nailed ? - ANS to the furring strips between the boards . what can be installed on a vertical wall to accept viny soppit panels ? - ANS F-Channel a vapor retarder on blanket insulation - ANS Face the warm side of wall when installing shoe molding on a base board over hand wood floor , the shoe mold should be ? - ANS nailed only to the base board to facilitate handling + workability ... must speak jobsite addition of water to the concrete mixture - ANS maintain the slump, without exceeding the allow water - cement ratio . Actual standard size of a concrete block ? - ANS 7 5/8 x 7 5/8 x 15 5/8 Maximum threshold height of egress door , of group occupancy building ? - ANS 1/2 inch First leveling procedure after pouring concrete ? - ANS screeding timing for floating+ trouling is critical inproduce - ANS a smooth durable surface when applying a run of wall cabinets , the cabinets should be? - ANS fitted with a hanger rail