NX Basic Design Questions with Detailed Verified Answers

Page | 1



NX Basic Design Questions with
Detailed Verified Answers

Question:What area of the NX user interface will prompt the user on what to
do?


Ans: Cue Line


Question: What part of the NX user interface is used to locate and activate a
specific command that is associated with one or more words or phrases?


Ans: Command Finder


Question: Which of the following are located on the Resource bar?


Ans: Part Navigator


Question: When the cursor is over more than one object what tool can be
used to cycle through the possible candidate objects?


Ans: QuickPick


Question: In the NX user interface, the availability and layout of commands
are organized by what to support the different major workflows?


Ans: Applications

, Page | 2

Question: What do the Roles control?


Ans: The buttons displayed in the ribbon groups


Question: If you don't see the commands you want to use what is one way to
display them?


Ans: Change your role


Question: You find a command with the Command Finder that is not
currently displayed on the Ribbon bar. How can you start the command?


Ans: Click the command in Command Finder


Question: The Roles Tab is located on the _____?


Ans: Resource Bar


Question: When creating an Offset - Datum CSYS what type of Reference
CSYS must be used to establish associativity to an existing Datum Coordinate
System?


Ans: Selected CSYS


Question: What type of operation is used to create a single solid body out of
two or more existing solid bodies?


Ans: Unite

, Page | 3

Question: To extrude a sketch curve until a point where the curve crosses
another curve or edge, which of the following options would you use?


Ans: Stop at Intersection


Question: Which extrude limit requires you to select a face?


Ans: Until Extended


Question: Which of the following are Boolean operations?


Ans: Unite, Subtract, Intersect


Question: What is used to control whether objects are visible and selectable?


Ans: Layer Settings


Question: On which layer are all new objects created?


Ans: Work layer


Question: How can you temporarily remove all the Sketches and Datums
from the graphics window display if all the geometry is on the same layer?


Ans: Use the Show and Hide command


Question: What is one way invoking the radial toolbar?