NEIEP 825 Unit Review Exam Questions With Accurate Solutions.

NEIEP 525 Exam Questions With Accurate Answers.

Horizontal slide, swing door, vertical slide biparting doors - accurate answers-
List at least two types of entrances used for passenger elevators

3 - accurate answers-On passenger elevators with automatic leveling, the sill
guard must extend the leveling distance below the floor plus _______ inches

Two-speed, horizontal sliding - accurate answers-On service and hospital
elevators requiring a wider opening, with the same space available post-wise
as for a single speed, horizontal sliding entrance, a _______ entrance is usually
installed

Fast door and slow door - accurate answers-Door panels in a two-speed,
horizontal sliding entrance are referred to as the _______ and the _______

2 1/4 - accurate answers-On automatic elevators with horizontal sliding
doors, the distance from the hoistway face (not the edge) of the door to the
edge of the sill cannot exceed _______ inches

Opening, inside - accurate answers-The direction of travel of the door panel,
when _______ as viewed from _______ the elevator car, looking out, determines
the hand of the door.

5/8" - accurate answers-Horizontal sliding doors must overlap the entrance
frame by _______

3/8" - accurate answers-On horizontal sliding doors, the distance from the
bottom of the door panel to the sill cannot exceed _______

Relating - accurate answers-_______ devices are used when more than one door
panel is used in an entrance

Drive, trailing - accurate answers-For center-opening horizontal doors, the
hoistway door engaged by the car door is called _______ door, while the other
hoistway door is referred to as the _______ door

, 1/2" - accurate answers-When a center-opening door is fully closed, the gap
between the leading edge faces shall not exceed _______

1/2" - accurate answers-On center-opening doors, the distance from the door
edge or sight guard if installed to the edge of the sill on the hoistway side, shall
not exceed _______

1/4" - accurate answers-Door guides for horizontal sliding doors must be
within the sill groove at least _______

3/4" - accurate answers-The distance between the inside face of a swing door
panel to the edge of the sill shall not be more than _______

1/2" - accurate answers-The swing door when closed against the frame
should overlap the top and sides by at least _______

3/8" - accurate answers-The clearance between the bottom of the swing door
and the sill shall not exceed _______

1/4 inch thick - accurate answers-If vision panels are installed, the glass must
be no less than _______

Self-closing and self-locking - accurate answers-When swing doors are used as
emergency accesses on blind hoistways, they must be _______

Automatic door closer - accurate answers-On automatic elevators, the swing
door must close by an _______ if the car leaves the landing zone

Partial - accurate answers-Most elevator entrances installed today use _______
strut angle

42 inches in height - accurate answers-Barricades around the hoistway
entrance must be at least _______

4 inches in height - accurate answers-The barricade toeboard must be at least
_______

Supply and return - accurate answers-A GFCI will open a circuit if it senses an
imbalance between _______ current