ASE G1 – Questions With Appropriate Solutions
Coolant should be tested for - a. Proper color
b. Freezing point (temperature)
c. Specific gravity
*d. Both b and c
Two technicians are discussing a compression test. Technician A
says that the engine
should be cranked over with the pressure gauge installed for "4
puffs." Technician B says
that the maximum difference between the highest-reading cylinder
and the lowest-reading
cylinder should be 20%. Which technician is correct? - a.
Technician A only
b. Technician B only
*c. Both Technicians A and B
d. Neither Technician A nor B
Technician A says that oil should be squirted into all of the cylinders
before taking a
compression test. Technician B says that if the compression greatly
increases when some oil
is squirted into the cylinders, it indicates defective or worn piston
rings. Which technician is
correct? - a. Technician A only
*b. Technician B only
c. Both Technicians A and B
d. Neither Technician A nor B
During a cylinder leakage (leak-down) test, air is noticed coming out
of the oil fill opening.
, Technician A says that the oil filter may be clogged. Technician B
says that the piston rings may be worn or defective. Which
technician is correct? - a. Technician A only
*b. Technician B only
c. Both Technicians A and B
d. Neither Technician A nor B
Leaking antifreeze can be what color? - a. Green
b. Orange
c. Red
*d. Any of the above
What precautions are needed to be performed to help prevent air
from getting trapped in
the cooling system when replacing coolant? - a. Use the
proper antifreeze as specified
*b. Open bleeder valve(s) during filling
c. Use premixed coolant
d. Wear protective gloves
When replacing a water pump, be sure to - a. Torque all
fasteners to factory specifications
b. Use a new gasket/ seal
c. Check that the accessory drive belt is properly aligned and
adjusted to the proper
tension
*d. All of the above
When using a scan tool to retrieve diagnostic trouble codes (DTCs),
the technician should
also - a. Check monitor status
b. Check freeze frame data
c. Record any stored DTCs
*d. All of the above
Coolant should be tested for - a. Proper color
b. Freezing point (temperature)
c. Specific gravity
*d. Both b and c
Two technicians are discussing a compression test. Technician A
says that the engine
should be cranked over with the pressure gauge installed for "4
puffs." Technician B says
that the maximum difference between the highest-reading cylinder
and the lowest-reading
cylinder should be 20%. Which technician is correct? - a.
Technician A only
b. Technician B only
*c. Both Technicians A and B
d. Neither Technician A nor B
Technician A says that oil should be squirted into all of the cylinders
before taking a
compression test. Technician B says that if the compression greatly
increases when some oil
is squirted into the cylinders, it indicates defective or worn piston
rings. Which technician is
correct? - a. Technician A only
*b. Technician B only
c. Both Technicians A and B
d. Neither Technician A nor B
During a cylinder leakage (leak-down) test, air is noticed coming out
of the oil fill opening.
, Technician A says that the oil filter may be clogged. Technician B
says that the piston rings may be worn or defective. Which
technician is correct? - a. Technician A only
*b. Technician B only
c. Both Technicians A and B
d. Neither Technician A nor B
Leaking antifreeze can be what color? - a. Green
b. Orange
c. Red
*d. Any of the above
What precautions are needed to be performed to help prevent air
from getting trapped in
the cooling system when replacing coolant? - a. Use the
proper antifreeze as specified
*b. Open bleeder valve(s) during filling
c. Use premixed coolant
d. Wear protective gloves
When replacing a water pump, be sure to - a. Torque all
fasteners to factory specifications
b. Use a new gasket/ seal
c. Check that the accessory drive belt is properly aligned and
adjusted to the proper
tension
*d. All of the above
When using a scan tool to retrieve diagnostic trouble codes (DTCs),
the technician should
also - a. Check monitor status
b. Check freeze frame data
c. Record any stored DTCs
*d. All of the above
