EPA SECTION 608 TYPE I, TYPE II , TYPE III

EPA SECTION 608 TYPE I, TYPE II , TYPE III What is typically used on small appliances as a service aperture or other device for adding or removing refrigerant? a. A straight piece of tubing that is entered using a piercing access tube. b. A line located 15 inches below the compressor. c. A valve installed at the factory which has a ¼ inch diameter and machine threads. d. A service aperture is not present because small appliances are exempt from this requirement. - correct answer- a. A straight piece of tubing that is entered using a piercing access tube. What type of appliances are technicians certified to service after passing the type 1 examination? a. Appliances containing 5 pounds or less of refrigerant that have been hermetically sealed and charged at the factory. b. Split systems containing 5 pounds or less of refrigerant that have been hermetically sealed and charged at the factory. c. Appliances containing 5 pounds or less of refrigerant that have an open drive compressor and have been charged at the factory. d. Motor vehicle air conditioning equipment. - correct answer- a. Appliances containing 5 pounds or less of refrigerant that have been hermetically sealed and charged at the factory. What type of certification is required for persons recovering CFC's, HCFCs, or HFCs during maintenance, service, or repair of small appliances. a. Type II technician. b. Type III technician. c. Type I technician. d. Technician who has passed the core exam. - correct answer- c. Type I technician. EPA Section 608 rules require capture of 80% of the HCFC and HFCs from a small appliance sealed systems with a non-operating compressor if technicians are using; a. a system-dependent (passive) process.