NOCTI ELECTRICAL EXAM 2025/2026 /EXPERT VERIFIED
ACTUAL COMPLETE REAL EXAM QUESTIONS AND CORRECT
ANSWERS (VERIFIED ANSWERS) GUARANTEED PASS!!!
NEWEST UPDATE.
In walls or ceilings combustible material, box set back must be
____ inch with the finished surface. - ANSWER-0
How many current carrying conductors are needed between
two three-way switches? - ANSWER-3
When installing 2 ground rods, what is the minimum distance
between them? - ANSWER-6'
What device automatically energizes a lighting circuit? -
ANSWER-Occupancy sensor
The maximum allowable weight of a fixture directly attached to
an outlet is -
ANSWER-50 pounds
Another name given to finish wiring is _____ out. - ANSWER-
Trim
,If a three-way switch lighting circuit works from one switch and
not the other, the most probable cause is - ANSWER-The
traveler wires are not on proper connections
What is the multiplier for a 15 degree offset? - ANSWER-4
When a light fixture is to be placed in a ceiling filled with
insulation, what type of light needs to be used? - ANSWER-
Type IC
Currently DSL service is offered by - ANSWER-Telephone
companies
The acronym AFCI stands for - ANSWER-Arc fault circuit
interrupter
What is the multiplier for a 30 degree offset? - ANSWER-2
Which task below must be completed before a switched duplex
receptacle works properly? - ANSWER-The tabs between two
hot screws must be broken.
All 120-volt, single phase, 15- and 20- ampere branch circuits
supplying outlets installed in dwelling unit bedrooms shall be
protected by a/an - ANSWER-Arc fault circuit interrupter (AFCI)
, To control a loan from four locations, the switches needed are -
ANSWER-Two three-way switches and two four-way switches
What is the multiplier for a 10 degree offset? - ANSWER-6
When installing boxes, the gap around the box cannot be
greater than _____ inch or the gap must be repaired. -
ANSWER-1/8
How long are ground Rods? - ANSWER-8'
The slowest connect to the Internet is a_________ connection.
– ANSWER-Dail-up
When supplying voltage to a switched receptacle, the hot and
switched voltage must be supplied from - ANSWER-The same
breaker
When troubleshooting fluorescent and HID lighting fixtures,
what is replaced first? - ANSWER-Lamp
What is the take up for 1" EMT on a hand bender? - ANSWER-8"
ACTUAL COMPLETE REAL EXAM QUESTIONS AND CORRECT
ANSWERS (VERIFIED ANSWERS) GUARANTEED PASS!!!
NEWEST UPDATE.
In walls or ceilings combustible material, box set back must be
____ inch with the finished surface. - ANSWER-0
How many current carrying conductors are needed between
two three-way switches? - ANSWER-3
When installing 2 ground rods, what is the minimum distance
between them? - ANSWER-6'
What device automatically energizes a lighting circuit? -
ANSWER-Occupancy sensor
The maximum allowable weight of a fixture directly attached to
an outlet is -
ANSWER-50 pounds
Another name given to finish wiring is _____ out. - ANSWER-
Trim
,If a three-way switch lighting circuit works from one switch and
not the other, the most probable cause is - ANSWER-The
traveler wires are not on proper connections
What is the multiplier for a 15 degree offset? - ANSWER-4
When a light fixture is to be placed in a ceiling filled with
insulation, what type of light needs to be used? - ANSWER-
Type IC
Currently DSL service is offered by - ANSWER-Telephone
companies
The acronym AFCI stands for - ANSWER-Arc fault circuit
interrupter
What is the multiplier for a 30 degree offset? - ANSWER-2
Which task below must be completed before a switched duplex
receptacle works properly? - ANSWER-The tabs between two
hot screws must be broken.
All 120-volt, single phase, 15- and 20- ampere branch circuits
supplying outlets installed in dwelling unit bedrooms shall be
protected by a/an - ANSWER-Arc fault circuit interrupter (AFCI)
, To control a loan from four locations, the switches needed are -
ANSWER-Two three-way switches and two four-way switches
What is the multiplier for a 10 degree offset? - ANSWER-6
When installing boxes, the gap around the box cannot be
greater than _____ inch or the gap must be repaired. -
ANSWER-1/8
How long are ground Rods? - ANSWER-8'
The slowest connect to the Internet is a_________ connection.
– ANSWER-Dail-up
When supplying voltage to a switched receptacle, the hot and
switched voltage must be supplied from - ANSWER-The same
breaker
When troubleshooting fluorescent and HID lighting fixtures,
what is replaced first? - ANSWER-Lamp
What is the take up for 1" EMT on a hand bender? - ANSWER-8"
