PRE-SOLO WRITTEN Exam Questions
and Answers Already Graded A+ Latest
Updates 2025
What grade or grades of fuel can be safely used in your
aircraft? What are the colors of the recommended fuels?
What happens to the color if two grades are mixed? -
CORRECT ANSWER -100LL-Blue
-Fuel becomes clear in color
What are the minimum and maximum oil capacities for
your training airplane? - CORRECT ANSWER Min: 5
quarts/ Max: 8 quarts
Under what circumstances should you use carb heat? -
CORRECT ANSWER - Anytime at a low power setting
- When RPMs are lower than 2000
- Anytime suspect reduction in power from carb ice
If during a flight, you experience carb ice and full carb heat
is applied, what changes in engine performance would you
expect? - CORRECT ANSWER When first apply carb
heat expect engine to run rougher(lose RPMs) may need
to lean mix to correct that, then once ice is melted it will
run better(increase RPMS)
,Under what circumstances could a spin occur in your
training airplane? - CORRECT ANSWER Un-
Coordinated Stall during any phase of flight
Describe the spin recovery procedures for your training
aircraft? - CORRECT ANSWER (PARE)
Power- Idle
Ailerons- Neutral
Rudder- Full opposite direction
Elevator- Sharply Forward
How do you enter and exit the traffic pattern at your
airport. What radio communications are required? (AIM.
chp. 4 sec. 3) - CORRECT ANSWER Enter pattern in
level flight, 45 degree to the downwind, abeam the
midpoint of the runway, at pattern altitude. Radio
communication should be on 122.70
Describe how you would approach and enter the traffic
pattern at an uncontrolled airport?(AIM. chp. 4 sec. 3) -
CORRECT ANSWER Approach at 45 degree angle on
downwind at pattern altitude
What are the traffic patterns for each runway at your home
airport? What is the MSL altitude for the traffic
pattern?(AIM. sec. 3) - CORRECT ANSWER Crosswind,
downwind, base leg, and final approach. Start pattern at
1100 MSL. All patterns are left
What radio calls are recommended as you approach and
fly in the traffic pattern at an uncontrolled airport? (AIM.
, chp.4 sec. 3) - CORRECT ANSWER Make radio call 10
miles out, make call when at 45 degree of downwind, radio
call entering each pattern, downwind, base, final
approach, clear runway.
What are typical dimensions of class D airspace and what
requirements must be met prior to entry? (FAR 91.129) -
CORRECT ANSWER 4nm, ceiling around 2500 AGL,
establish and maintain two way communication with ATC
prior to entering airspace
What is CTAF? Explain the CTAF procedures at your
home airport. - CORRECT ANSWER Common traffic
advisory frequency. Call 5-10 miles away declaring your
plan on entering pattern, call again 1-2 miles out, enter on
45 on downwind. Call your position as you fly around
pattern. CTAF: 122.70
If you receive ATC instructions that you do not understand
or feel may compromise safety, what should you do?(FAR.
91.3) - CORRECT ANSWER Ask ATC to repeat/ If
compromises safety say "unable" or ask for a different
clearance- pilot in command has final authority
What is the meaning of each of the following ATC light
signals?(IN FLIGHT) Green, flashing green, red, flashing
red, white? (FAR 91.125) - CORRECT ANSWER Clear
to land, return for landing, give way/continue circle, airport
unsafe/ don't land, return to starting point
and Answers Already Graded A+ Latest
Updates 2025
What grade or grades of fuel can be safely used in your
aircraft? What are the colors of the recommended fuels?
What happens to the color if two grades are mixed? -
CORRECT ANSWER -100LL-Blue
-Fuel becomes clear in color
What are the minimum and maximum oil capacities for
your training airplane? - CORRECT ANSWER Min: 5
quarts/ Max: 8 quarts
Under what circumstances should you use carb heat? -
CORRECT ANSWER - Anytime at a low power setting
- When RPMs are lower than 2000
- Anytime suspect reduction in power from carb ice
If during a flight, you experience carb ice and full carb heat
is applied, what changes in engine performance would you
expect? - CORRECT ANSWER When first apply carb
heat expect engine to run rougher(lose RPMs) may need
to lean mix to correct that, then once ice is melted it will
run better(increase RPMS)
,Under what circumstances could a spin occur in your
training airplane? - CORRECT ANSWER Un-
Coordinated Stall during any phase of flight
Describe the spin recovery procedures for your training
aircraft? - CORRECT ANSWER (PARE)
Power- Idle
Ailerons- Neutral
Rudder- Full opposite direction
Elevator- Sharply Forward
How do you enter and exit the traffic pattern at your
airport. What radio communications are required? (AIM.
chp. 4 sec. 3) - CORRECT ANSWER Enter pattern in
level flight, 45 degree to the downwind, abeam the
midpoint of the runway, at pattern altitude. Radio
communication should be on 122.70
Describe how you would approach and enter the traffic
pattern at an uncontrolled airport?(AIM. chp. 4 sec. 3) -
CORRECT ANSWER Approach at 45 degree angle on
downwind at pattern altitude
What are the traffic patterns for each runway at your home
airport? What is the MSL altitude for the traffic
pattern?(AIM. sec. 3) - CORRECT ANSWER Crosswind,
downwind, base leg, and final approach. Start pattern at
1100 MSL. All patterns are left
What radio calls are recommended as you approach and
fly in the traffic pattern at an uncontrolled airport? (AIM.
, chp.4 sec. 3) - CORRECT ANSWER Make radio call 10
miles out, make call when at 45 degree of downwind, radio
call entering each pattern, downwind, base, final
approach, clear runway.
What are typical dimensions of class D airspace and what
requirements must be met prior to entry? (FAR 91.129) -
CORRECT ANSWER 4nm, ceiling around 2500 AGL,
establish and maintain two way communication with ATC
prior to entering airspace
What is CTAF? Explain the CTAF procedures at your
home airport. - CORRECT ANSWER Common traffic
advisory frequency. Call 5-10 miles away declaring your
plan on entering pattern, call again 1-2 miles out, enter on
45 on downwind. Call your position as you fly around
pattern. CTAF: 122.70
If you receive ATC instructions that you do not understand
or feel may compromise safety, what should you do?(FAR.
91.3) - CORRECT ANSWER Ask ATC to repeat/ If
compromises safety say "unable" or ask for a different
clearance- pilot in command has final authority
What is the meaning of each of the following ATC light
signals?(IN FLIGHT) Green, flashing green, red, flashing
red, white? (FAR 91.125) - CORRECT ANSWER Clear
to land, return for landing, give way/continue circle, airport
unsafe/ don't land, return to starting point
