Ca Smog Check Inspector Training Final
Review (Part 1)
equipped with dual tanks, tanks over 50 gal, vehicles for which no adapter is available,
or have inaccessible canisters, unless the vapor line is accessible. - ans-All vehicles
1976-1995 receive a LPFET, unless ___________.
Idle Test, Crankcase Test, BAR Snap Test - ans-What are the three parts of a "visible
smoke test" on a gasoline vehicle?
Automatic transmission in its normal driving gear, manual transmission in second
gear - ans-What gear should be used when performing an ASM emissions test?
Faulty brakes, low oil pressure, large coolant leak, tire failure, gasoline leaks, engine
noise, overheating - ans-These items can cause a vehicle to be rejected from an
inspection.
Tire pressure, missing emission label, traction control - ans-These items are not a
reason to reject vehicle from an inspection
Stoichiometry - ans-What is the term for ideal combustion efficiency?
Advise the vehicle owner to have the vehicle diagnosed to determine the cause of the
failure - ans-If a vehicle fails an inspection for any reason, what should the technician
do?
Use the VIN on the vehicle and continue with the inspection. - ans-If the VIN on the
registration and vehicle differ, what action should the technician take?
, Notify the customer both orally and in writing that they are unable to repair if it fails. -
ans-If a test and repair station does not have the tools/equipment to repair a vehicle,
what must be done prior to accepting a vehicle for an inspection.
Location of liquid fuel leak, reason for smoke test failure, E.O. numbers for
aftermarket parts, component which fails in "other" category, monitors not run to
completion, location of inaccessible canister for LPFET. - ans-What must be noted on a
VIR?
Check for a BAR Referee Label, and continue with the test if equipped. - ans-A vehicle
has been converted from diesel to gasoline. All equipment is installed for the
conversion. What action should the inspector take?
Verify the aftermarket parts are approved. - ans-What action should taken be when
testing a vehicle with aftermarket parts?
Basic - ans-What program area performs only TSI tests on a biennial basis?
Enhanced - ans-What program area performs both TSI & ASM tests on a biennial basis?
Change of ownership - ans-What program area performs only TSI tests on change of
ownership?
After the tail pipe sampling part of the test. - ans-When is the tailpipe (idle) smoke test
performed during a BAR97 inspection?
When the OIS prompts you. - ans-When is the tailpipe (idle) smoke test performed
during a OIS inspection?
Obtain the part's identification numbers/name, and refer to the parts, manufacturer's
catalogs/website to see it is designated as either a replacement part, and/or allowed
for street use on emission-controlled vehicles. - ans-What action should be taken
when testing a vehicle with an aftermarket carburetor?
Review (Part 1)
equipped with dual tanks, tanks over 50 gal, vehicles for which no adapter is available,
or have inaccessible canisters, unless the vapor line is accessible. - ans-All vehicles
1976-1995 receive a LPFET, unless ___________.
Idle Test, Crankcase Test, BAR Snap Test - ans-What are the three parts of a "visible
smoke test" on a gasoline vehicle?
Automatic transmission in its normal driving gear, manual transmission in second
gear - ans-What gear should be used when performing an ASM emissions test?
Faulty brakes, low oil pressure, large coolant leak, tire failure, gasoline leaks, engine
noise, overheating - ans-These items can cause a vehicle to be rejected from an
inspection.
Tire pressure, missing emission label, traction control - ans-These items are not a
reason to reject vehicle from an inspection
Stoichiometry - ans-What is the term for ideal combustion efficiency?
Advise the vehicle owner to have the vehicle diagnosed to determine the cause of the
failure - ans-If a vehicle fails an inspection for any reason, what should the technician
do?
Use the VIN on the vehicle and continue with the inspection. - ans-If the VIN on the
registration and vehicle differ, what action should the technician take?
, Notify the customer both orally and in writing that they are unable to repair if it fails. -
ans-If a test and repair station does not have the tools/equipment to repair a vehicle,
what must be done prior to accepting a vehicle for an inspection.
Location of liquid fuel leak, reason for smoke test failure, E.O. numbers for
aftermarket parts, component which fails in "other" category, monitors not run to
completion, location of inaccessible canister for LPFET. - ans-What must be noted on a
VIR?
Check for a BAR Referee Label, and continue with the test if equipped. - ans-A vehicle
has been converted from diesel to gasoline. All equipment is installed for the
conversion. What action should the inspector take?
Verify the aftermarket parts are approved. - ans-What action should taken be when
testing a vehicle with aftermarket parts?
Basic - ans-What program area performs only TSI tests on a biennial basis?
Enhanced - ans-What program area performs both TSI & ASM tests on a biennial basis?
Change of ownership - ans-What program area performs only TSI tests on change of
ownership?
After the tail pipe sampling part of the test. - ans-When is the tailpipe (idle) smoke test
performed during a BAR97 inspection?
When the OIS prompts you. - ans-When is the tailpipe (idle) smoke test performed
during a OIS inspection?
Obtain the part's identification numbers/name, and refer to the parts, manufacturer's
catalogs/website to see it is designated as either a replacement part, and/or allowed
for street use on emission-controlled vehicles. - ans-What action should be taken
when testing a vehicle with an aftermarket carburetor?
