DaVita star learning with correct answers 100%

DaVita star learning with correct answers 100% The primary electrolyte in both our blood and the dialysate is... - Correct Answers sodium Policy states the conductivity meter should be calibrated when an inaccurate reading is suspected. It should also be calibrated: - Correct Answers prior to daily use When the dialysate sodium level is higher than the level in the blood: - Correct Answers Diffusion will cause sodium to move into the blood The calibration of the conductivity meter should be completed at least... - Correct Answers daily Hypernatremia can lead to... - Correct Answers -Excessive thirst Decreased weight gains between treatments Comparing the displayed machine conductivity and your manual conductivity reading with the Fresenius machine's TCD reading helps to... - Correct Answers -Assure the machine reading is accurate - Identify malfunctions of the machine's proportioning system - Identify malfunctions of the machine's alarm/bypass system When comparing a manual conductivity reading to the applicable machine conductivity reading, the difference in readings should be no greater than.. - Correct Answers 0.4 mS/cm If, after recalibrating the conductivity meter and retesting the machine, the difference between the manual and applicable machine conductivity remains greater than 0.4 mS/cm, one should.... - Correct Answers Remove the machine, tag the machine, and notify biomed. True/false: A manual conductivity reading should not be completed when the machine is in bypass mode. - Correct Answers true True/false: The primary reason for comparing a manual conductivity with the applicable machine conductivity is to assure patient safety. - Correct Answers true Machine alarm tests are performed: - Correct Answers Before the initiation of each patient treatment Once set up for treatment, the recirculation time for a dialyzer should not exceed - Correct Answers 2 hours The manual conductivity must match the Fresenius (FMC) dialysis delivery system displayed conductivity - Correct Answers +/- 0.4mS To prepare a 1:100 bleach solution, you would - Correct Answers Add 1 part of bleach to 99 parts of water What happens if bleach and peracetic acid are mixed? - Correct Answers A chemical reaction occurs, producing toxic chlorine gas What is the correct procedure for residual bleach testing after chemical disinfection of distribution loops and equipment fluid pathways? - Correct Answers Residual bleach testing is performed after bleach disinfection and prior to use What is the safe range for dialysate pH? - Correct Answers Between 6.9 and 7.6 Why is a "strikethrough"‖ of an external pressure transducer protector of concern? - Correct Answers Fluid could have entered the machine and contaminated the internal pressure transducer protector providing a reservoir for microorganisms and causing subsequent patient blood infections Why is it important for patient care teammates to know when the water treatment system is disinfected using an end-to end disinfection process? - Correct Answers The end-to-end disinfection process will also introduce the disinfectant solution to the dialysis delivery systems through their water inlet lines A 1:10 bleach solution is used to - Correct Answers Clean up visible blood or gross blood spills The three processes that make up the water treatment