J-STD-001E
After cleaning, you observe particulate matter left on the assembly and correctly identify
the condition as _______ - ✔️✔️D1D2D3
When an external flux is used in conjunction with flux cored solders, the fluxes shall be
________ - ✔️✔️compatible.
A product classification where continued high performance of performance-on-demand
is critical describes a _______ product. - ✔️✔️Class 3
A Class 1 Product includes product where ______ - ✔️✔️the major requirement is
function of the completed assembly.
During an audit an employee is found using tobacco products in the work area. this
would be? - ✔️✔️D1D2D3
The IPC-T- 50 document provides _________ - ✔️✔️terms and definitions.
Solder alloys shall be in accordance with J-STD- ____ or equivalent. - ✔️✔️006
A solder connection that appears dull, matte, satin, gray, or grainy and is normal for the
material or process involved is considered? - ✔️✔️Acceptable.
All IPC certification programs for MIT, CIT, and CIS require re-certification after what
period of time? - ✔️✔️2 years.
Component damage that exposes the component substrate or active element or affects
structural integrity is? - ✔️✔️D1D2D3
Hardware characteristics or conditions that do not conform to the requirements of this
specification are classified as ____________ - ✔️✔️Hardware defects or hardware
process indicators.
The __________ always takes precedence over this standard, referenced standards
and drawings. - ✔️✔️contract
When a clause in this document is referenced, - ✔️✔️its subordinate clauses also
apply.
This drawing represents? - ✔️✔️Wire overwrap.
After cleaning, you observe particulate matter left on the assembly and correctly identify
the condition as _______ - ✔️✔️D1D2D3
When an external flux is used in conjunction with flux cored solders, the fluxes shall be
________ - ✔️✔️compatible.
A product classification where continued high performance of performance-on-demand
is critical describes a _______ product. - ✔️✔️Class 3
A Class 1 Product includes product where ______ - ✔️✔️the major requirement is
function of the completed assembly.
During an audit an employee is found using tobacco products in the work area. this
would be? - ✔️✔️D1D2D3
The IPC-T- 50 document provides _________ - ✔️✔️terms and definitions.
Solder alloys shall be in accordance with J-STD- ____ or equivalent. - ✔️✔️006
A solder connection that appears dull, matte, satin, gray, or grainy and is normal for the
material or process involved is considered? - ✔️✔️Acceptable.
All IPC certification programs for MIT, CIT, and CIS require re-certification after what
period of time? - ✔️✔️2 years.
Component damage that exposes the component substrate or active element or affects
structural integrity is? - ✔️✔️D1D2D3
Hardware characteristics or conditions that do not conform to the requirements of this
specification are classified as ____________ - ✔️✔️Hardware defects or hardware
process indicators.
The __________ always takes precedence over this standard, referenced standards
and drawings. - ✔️✔️contract
When a clause in this document is referenced, - ✔️✔️its subordinate clauses also
apply.
This drawing represents? - ✔️✔️Wire overwrap.
