Ramsey Test |42 Accurate Q’s and
A’s
The term used to indicate opposition to current flow is ____. - -resistance
- The term used to indicate power is ____. - -wattage
- The letters NO represent ____. - -normally open
- Inductive proximity switches will not detect ____. - -Plastic
- A retro-reflective device transmits the light to a reflector and detects the
reflected light at its receiver. (Y/N) - -Yes
- ____ switches are noncontact-type switches that are used to sense the
presence or absence of an object without actually contacting the object. - -
Proximity
- The voltage that is set for the desired speed of the motor is called the ____.
- -reference signal
- The signal that represents the difference between the control signal and
the feedback signal is called the ____. - -error signal
- A motor may be controlled manually by a ____. - -toggle switch
- A jog switch applies power to the motor as long as the switch is ____. - -
closed
- The purpose of the start-capacitor in the capacitor-start motor is ____. - -to
produce a higher starting torque than that found in the split-phase motor
- The difference between a motor starter and a relay or contactor is that a
motor starter also contains ____________________ protection for the motor. - -
overload
- When voltage is measured with the voltmeter portion of a digital
multimeter, the leads should be connected ____ to the portion of the circuit
being tested. - -in parallel
- When measuring the resistance of a circuit, you should ____. - -test the
circuit de-energized
A’s
The term used to indicate opposition to current flow is ____. - -resistance
- The term used to indicate power is ____. - -wattage
- The letters NO represent ____. - -normally open
- Inductive proximity switches will not detect ____. - -Plastic
- A retro-reflective device transmits the light to a reflector and detects the
reflected light at its receiver. (Y/N) - -Yes
- ____ switches are noncontact-type switches that are used to sense the
presence or absence of an object without actually contacting the object. - -
Proximity
- The voltage that is set for the desired speed of the motor is called the ____.
- -reference signal
- The signal that represents the difference between the control signal and
the feedback signal is called the ____. - -error signal
- A motor may be controlled manually by a ____. - -toggle switch
- A jog switch applies power to the motor as long as the switch is ____. - -
closed
- The purpose of the start-capacitor in the capacitor-start motor is ____. - -to
produce a higher starting torque than that found in the split-phase motor
- The difference between a motor starter and a relay or contactor is that a
motor starter also contains ____________________ protection for the motor. - -
overload
- When voltage is measured with the voltmeter portion of a digital
multimeter, the leads should be connected ____ to the portion of the circuit
being tested. - -in parallel
- When measuring the resistance of a circuit, you should ____. - -test the
circuit de-energized
