Maintenance Exam 1 questions well
answered to pass
Reliability of a system is also referred to as the - correct answer ✔✔design-in level
of perfection
The design engineer's role is to - correct answer ✔✔design a system with low
entropy
The time of failure can only be predicted on - correct answer ✔✔11% of items
Maintenance can be scheduled daily, every flight, or every 100 cycles. A cycle is -
correct answer ✔✔a takeoff and landing
89% of aircraft components must be operated to failure before replacement or
repair is done. This results in the need for - correct answer ✔✔unscheduled
maintenance
The design of aircraft systems is limited by - correct answer ✔✔natural entropy,
man-made entropy
What are three types of structural inspection techniques? - correct answer
✔✔general visual, detailed, and special detailed
, The ___ check established under the Maintenance Steering Group (MSG)-3 is
designed to determine if each item's function performs within specified limits -
correct answer ✔✔functional
Hard Time (HT) requires that the item - correct answer ✔✔be removed and
completely overhauled, partially overhauled, or discarded before exceeding a
specific interval
Which of the following is NOT a source of structural deterioration (environmental
deterioration, accidental damage, fatigue damage, stress damage) - correct
answer ✔✔stress damage
The )) check is a failure-finding task established under MSG-3 designed to
determine if an item is fulfilling its purpose - correct answer ✔✔operational
The _____ approach to maintenance aka the 'bottom up' approach looked at
components as the most likely causes of equipment malfunction - correct answer
✔✔MSG
Operational checks - correct answer ✔✔operate the equipment to see if it is
fulfilling its intended purpose
Reliability centered maintenance (RCM) process was primarily for - correct answer
✔✔scheduled maintenance
The terms verification and validation are used to - correct answer ✔✔determine
the adequacy of maintenance processes and procedures
answered to pass
Reliability of a system is also referred to as the - correct answer ✔✔design-in level
of perfection
The design engineer's role is to - correct answer ✔✔design a system with low
entropy
The time of failure can only be predicted on - correct answer ✔✔11% of items
Maintenance can be scheduled daily, every flight, or every 100 cycles. A cycle is -
correct answer ✔✔a takeoff and landing
89% of aircraft components must be operated to failure before replacement or
repair is done. This results in the need for - correct answer ✔✔unscheduled
maintenance
The design of aircraft systems is limited by - correct answer ✔✔natural entropy,
man-made entropy
What are three types of structural inspection techniques? - correct answer
✔✔general visual, detailed, and special detailed
, The ___ check established under the Maintenance Steering Group (MSG)-3 is
designed to determine if each item's function performs within specified limits -
correct answer ✔✔functional
Hard Time (HT) requires that the item - correct answer ✔✔be removed and
completely overhauled, partially overhauled, or discarded before exceeding a
specific interval
Which of the following is NOT a source of structural deterioration (environmental
deterioration, accidental damage, fatigue damage, stress damage) - correct
answer ✔✔stress damage
The )) check is a failure-finding task established under MSG-3 designed to
determine if an item is fulfilling its purpose - correct answer ✔✔operational
The _____ approach to maintenance aka the 'bottom up' approach looked at
components as the most likely causes of equipment malfunction - correct answer
✔✔MSG
Operational checks - correct answer ✔✔operate the equipment to see if it is
fulfilling its intended purpose
Reliability centered maintenance (RCM) process was primarily for - correct answer
✔✔scheduled maintenance
The terms verification and validation are used to - correct answer ✔✔determine
the adequacy of maintenance processes and procedures
