©THESTAR 2024/2025 ALL RIGHTS RESERVED 11:42PM. A+
Home inspector test Exam Questions With
Correct Answers 100% Verified.
Which of the following soils can support the least load-bearing pressure? - Answer✔Silt with
high compressibility
In general, the grading around a building should be positively sloped for how many feet away
from the building? - Answer✔10 feet
Flashing is not required at which of the following locations? - Answer✔Above projecting
masonry
Under which of the following conditions is a two-coat stucco system acceptable on the exterior
of a building? - Answer✔If the system is installed over masonry or concrete
Which of the following locations is the worst place to cut a hole in an I-joist? - Answer✔Near
the end of the joist in the web
Why must building footings extend below the frost line? - Answer✔So that the soil around the
footing does not freeze, expand, and cause the footing to shift
Which of the following locations does not require a GFCI outlet? - Answer✔Receptacles that
serve appliances
Which of the following is a way that many homes' electrical systems are grounded? -
Answer✔Through a connection to the cold water piping
What are the types of heat that must be taken into account when calculating the cooling loads
for an HVAC system? - Answer✔Sensible and latent heat
How many BTU's per hour is a ton of cooling capacity in HVAC equipment equal to? -
Answer✔12,000 btu per hour
A gas furnace is being installed in a brand new building. What is the most likely reason that an
outdoor air source would be required? - Answer✔The building has unusually tight construction
1
, ©THESTAR 2024/2025 ALL RIGHTS RESERVED 11:42PM. A+
What is the purpose of an expansion tank in a hot water system? - Answer✔It allows the water
to expand as it warms without increasing the pressure in the system
Which of the following is not a code requirement for electric clothes dryer exhaust ducts? -
Answer✔The diameter of the duct must be per the manufacturer's requirements but not less
than 6"
The utility bills for heating and cooling a home are much higher than expected. Which of the
following choices is probably not a reason for this increased cost? - Answer✔The fresh air
intake for the HVAC system is incorrectly sized
Which of the following would be most likely to have the highest R-value? - Answer✔6"
fiberglass batt insulation
Which of the following is not a form of home inspection report? - Answer✔Disclaimer
The home inspection report should be delivered to the client: - Answer✔After the report has
been finalized by the home inspector
Home inspectors must inspect the low voltage wiring. True or false ? - Answer✔False
Home inspection standards generally require that the inspector test the drinking water quality.
True or false - Answer✔False
A typical exterior inspection includes an examination of the shutters, if they are part of the
structure. True or false - Answer✔False
Home inspectors must inspect readily accessible systems. True or false - Answer✔True
An example of a latent defect is a cracked sewer drain under the foundation. True or false -
Answer✔True
What is the minimum allowed slope of graded soil next to a building's foundation, according to
the International Residential Code (IRC)? - Answer✔¥ 6"/10'
Which of the following is not a solid fuel heating device? - Answer✔Electrical heater
Every basement and sleeping room is required to have an easily operable emergency escape
window. How large must this window be? - Answer✔At least 5.7 sq. ft
The roofing material on a house or other building is considered a part of the roof drainage
system. True or false - Answer✔False
You are inspecting a residential property. You have to observe and/or test all of the readily
accessible components of each system. Determine which of the following is not considered to
be a readily accessible component of a room. - Answer✔Nails or screws in the floor
2
Home inspector test Exam Questions With
Correct Answers 100% Verified.
Which of the following soils can support the least load-bearing pressure? - Answer✔Silt with
high compressibility
In general, the grading around a building should be positively sloped for how many feet away
from the building? - Answer✔10 feet
Flashing is not required at which of the following locations? - Answer✔Above projecting
masonry
Under which of the following conditions is a two-coat stucco system acceptable on the exterior
of a building? - Answer✔If the system is installed over masonry or concrete
Which of the following locations is the worst place to cut a hole in an I-joist? - Answer✔Near
the end of the joist in the web
Why must building footings extend below the frost line? - Answer✔So that the soil around the
footing does not freeze, expand, and cause the footing to shift
Which of the following locations does not require a GFCI outlet? - Answer✔Receptacles that
serve appliances
Which of the following is a way that many homes' electrical systems are grounded? -
Answer✔Through a connection to the cold water piping
What are the types of heat that must be taken into account when calculating the cooling loads
for an HVAC system? - Answer✔Sensible and latent heat
How many BTU's per hour is a ton of cooling capacity in HVAC equipment equal to? -
Answer✔12,000 btu per hour
A gas furnace is being installed in a brand new building. What is the most likely reason that an
outdoor air source would be required? - Answer✔The building has unusually tight construction
1
, ©THESTAR 2024/2025 ALL RIGHTS RESERVED 11:42PM. A+
What is the purpose of an expansion tank in a hot water system? - Answer✔It allows the water
to expand as it warms without increasing the pressure in the system
Which of the following is not a code requirement for electric clothes dryer exhaust ducts? -
Answer✔The diameter of the duct must be per the manufacturer's requirements but not less
than 6"
The utility bills for heating and cooling a home are much higher than expected. Which of the
following choices is probably not a reason for this increased cost? - Answer✔The fresh air
intake for the HVAC system is incorrectly sized
Which of the following would be most likely to have the highest R-value? - Answer✔6"
fiberglass batt insulation
Which of the following is not a form of home inspection report? - Answer✔Disclaimer
The home inspection report should be delivered to the client: - Answer✔After the report has
been finalized by the home inspector
Home inspectors must inspect the low voltage wiring. True or false ? - Answer✔False
Home inspection standards generally require that the inspector test the drinking water quality.
True or false - Answer✔False
A typical exterior inspection includes an examination of the shutters, if they are part of the
structure. True or false - Answer✔False
Home inspectors must inspect readily accessible systems. True or false - Answer✔True
An example of a latent defect is a cracked sewer drain under the foundation. True or false -
Answer✔True
What is the minimum allowed slope of graded soil next to a building's foundation, according to
the International Residential Code (IRC)? - Answer✔¥ 6"/10'
Which of the following is not a solid fuel heating device? - Answer✔Electrical heater
Every basement and sleeping room is required to have an easily operable emergency escape
window. How large must this window be? - Answer✔At least 5.7 sq. ft
The roofing material on a house or other building is considered a part of the roof drainage
system. True or false - Answer✔False
You are inspecting a residential property. You have to observe and/or test all of the readily
accessible components of each system. Determine which of the following is not considered to
be a readily accessible component of a room. - Answer✔Nails or screws in the floor
2
