MSSC Quality Exam 2 2025/2026 Study Guide (Graded A+)
A scale typically found on a tape measure is ______ - 1/16
Two systems of dimensional measurement used in manufacturing are the SI Metric System and the
_____ - US Customary System
A common decimal-inch graduation is _____ - 10ths, 50ths, 100ths
Resolution is sometimes called ____ - discrimination
A common scale on a machinist's rule is _____ - 150 mm
Dimensional measurement determines physical dimensions such as - width, height, depth, and
diameter
If the length of a part is 5.000 inches and the reading could be as much as 5.002 or as little as 4.998,
the accuracy is said to be ______ inches - +/- 0.002
A common fractional-inch rule graduation is in _____ - 32nds
A tape measure is used _____. - In manufacturing and construction industries
____ error occurs when the measurement we think we see is not the measurement being indicated
by the instrument - Observational
The conversion of 3-3/8 inches to decimal inches is _____ - 3.375 inches
The first step in dimensional measuring is to align the end of the rule where the zero is located with
one edge of the dimension you want to measure. The edge is called the ______ - reference point
One inch is equal to - 25.4 mm
A scale typically found on a tape measure is ______ - 1/16
Two systems of dimensional measurement used in manufacturing are the SI Metric System and the
_____ - US Customary System
A common decimal-inch graduation is _____ - 10ths, 50ths, 100ths
Resolution is sometimes called ____ - discrimination
A common scale on a machinist's rule is _____ - 150 mm
Dimensional measurement determines physical dimensions such as - width, height, depth, and
diameter
If the length of a part is 5.000 inches and the reading could be as much as 5.002 or as little as 4.998,
the accuracy is said to be ______ inches - +/- 0.002
A common fractional-inch rule graduation is in _____ - 32nds
A tape measure is used _____. - In manufacturing and construction industries
____ error occurs when the measurement we think we see is not the measurement being indicated
by the instrument - Observational
The conversion of 3-3/8 inches to decimal inches is _____ - 3.375 inches
The first step in dimensional measuring is to align the end of the rule where the zero is located with
one edge of the dimension you want to measure. The edge is called the ______ - reference point
One inch is equal to - 25.4 mm
