NCCER Electrical 1 Module 10 Exam Questions and Answers Latest Update 2025 Already Passed
Blue Prints - Answers An exact copy of reproduction of an original drawing
Floor plan - Answers As viewed from above
Site plan - Answers Location of building on the property
Surveys show - Answers All property lines, existing public utilities and their location on or near the
property
Elevation drawings show - Answers The exterior face of the building
Floor plans are in - Answers 2 dimension, length and width
Topographic survey shows - Answers Property lines, contour lines, notes and symbols
Sectional view - Answers Is a cutaway view that shows the inside of the building
Title block - Answers A table located in the bottom right-hand corner of an engineering drawing that
identifies, in an organized way, all of the necessary information that is not given on the drawing itself.
Also referred to as a title strip.
Revision Block - Answers Shows modifications or redrawn drawings
Architectural scale - Answers 1/16" = 1', 1/8" = 1' 1/4" = 1
Engineer scale measurements - Answers 1"=10 units through 1"=100 units
Metric scale 1:1 to 1:100 - Answers Millimeters are used
Metric scale 1:200 to 1:2000 - Answers Meter is used
CAD - Answers Computer aided design
Masterformat - Answers Most common used writing format
Division 26 is - Answers Electrical
Division 27 is - Answers Communications
Division 28 is - Answers Electronic safety and security
ANSI - Answers American National Standards Institute
The type of lighting fixture is identified by - Answers A numeral placed inside a triangle or other symbol
and placed near the fixture to be identified
A section line on a drawing shows - Answers The location of the section on the plan
Blue Prints - Answers An exact copy of reproduction of an original drawing
Floor plan - Answers As viewed from above
Site plan - Answers Location of building on the property
Surveys show - Answers All property lines, existing public utilities and their location on or near the
property
Elevation drawings show - Answers The exterior face of the building
Floor plans are in - Answers 2 dimension, length and width
Topographic survey shows - Answers Property lines, contour lines, notes and symbols
Sectional view - Answers Is a cutaway view that shows the inside of the building
Title block - Answers A table located in the bottom right-hand corner of an engineering drawing that
identifies, in an organized way, all of the necessary information that is not given on the drawing itself.
Also referred to as a title strip.
Revision Block - Answers Shows modifications or redrawn drawings
Architectural scale - Answers 1/16" = 1', 1/8" = 1' 1/4" = 1
Engineer scale measurements - Answers 1"=10 units through 1"=100 units
Metric scale 1:1 to 1:100 - Answers Millimeters are used
Metric scale 1:200 to 1:2000 - Answers Meter is used
CAD - Answers Computer aided design
Masterformat - Answers Most common used writing format
Division 26 is - Answers Electrical
Division 27 is - Answers Communications
Division 28 is - Answers Electronic safety and security
ANSI - Answers American National Standards Institute
The type of lighting fixture is identified by - Answers A numeral placed inside a triangle or other symbol
and placed near the fixture to be identified
A section line on a drawing shows - Answers The location of the section on the plan
