results from the destruction of the structure of the concrete, caused by the spread of
microcracking and overall cracking
Give this one a try later!
The slope of the descending branch of the stress- strain curve
,Standard Specification for Deformed and Plain Carbon-Steel Bars for Concrete
Reinforcement.
This specification covers the most commonly used rein- forcing bars.
Give this one a try later!
ASTM A 615
is the deformation of a structure under sustained load.
Give this one a try later!
Creep
is the decrease in the volume of concrete during hardening and drying under
constant temperature
Give this one a try later!
Shrinkage
The slope of a line that is tangent to a point on the stress-strain curve, such as A is
called the ________________ , at the stress corresponding to point A.
Give this one a try later!
, tangent modulus of elasticity, ET
A direct application of laws of statics and mechanics of materials to obtain a
successful design not only on design rules but is capable of being built in a timely
fashion for a reasonable cost and should provide a long service of life
Give this one a try later!
Reinforced Concrete Design
Design is based on ___________, also referred to as service loads or unfactored loads
Give this one a try later!
Working loads
is a state of impending failure, beyond which a structure ceases to perform its
intended function satisfactorily, in terms of either strength or serviceability.
Give this one a try later!
limit state
A function of the cost of materials. The overall cost should not exceed the client's
budget.
microcracking and overall cracking
Give this one a try later!
The slope of the descending branch of the stress- strain curve
,Standard Specification for Deformed and Plain Carbon-Steel Bars for Concrete
Reinforcement.
This specification covers the most commonly used rein- forcing bars.
Give this one a try later!
ASTM A 615
is the deformation of a structure under sustained load.
Give this one a try later!
Creep
is the decrease in the volume of concrete during hardening and drying under
constant temperature
Give this one a try later!
Shrinkage
The slope of a line that is tangent to a point on the stress-strain curve, such as A is
called the ________________ , at the stress corresponding to point A.
Give this one a try later!
, tangent modulus of elasticity, ET
A direct application of laws of statics and mechanics of materials to obtain a
successful design not only on design rules but is capable of being built in a timely
fashion for a reasonable cost and should provide a long service of life
Give this one a try later!
Reinforced Concrete Design
Design is based on ___________, also referred to as service loads or unfactored loads
Give this one a try later!
Working loads
is a state of impending failure, beyond which a structure ceases to perform its
intended function satisfactorily, in terms of either strength or serviceability.
Give this one a try later!
limit state
A function of the cost of materials. The overall cost should not exceed the client's
budget.
