Networking with Windows Server 2016 Chapter 1- Exam Solution Manual Solved 100%

Networking with Windows Server 2016 Chapter 1- Exam Solution Manual Solved 100% Which of the following is needed if a computer with the IP address 172.31.210.10/24 wants to communicate with a computer with the IP address 172.31.209.122/24? - Answers Router You have just typed the commands ipconfig /flushdns and ping server1. Which of the following protocols is used first as a result of these commands? - Answers DNS Which command should you use with a dual-homed server to make sure the server sends packets out to the correct interface? - Answers Route Which command should you use to determine whether there's a bottleneck between your computer and a computer on another network? - Answers Tracert Which command should you use to configure the primary DNS server on your computer? - Answers netsh Which IP address expressed in CIDR notation has the subnet mask 255.255.255.0? - Answers 10.100.44.123/24 Which IP network address expressed in CIDR notation can support a maximum of 1022 hosts? - Answers 172.16.4.0/22 You have just finished a default installation of Windows Server 2016. You know that TCP/IP is installed. How does your new server receive an assigned an IP address? - Answers DNS Your DNS server is on the same network as the computer where you enter the following commands: arp -d ipconfig /flushdns nslookup server1 Which of the following protocols is used first as a result of these commands? - Answers ARP (possibly DHCP) Which of the following IP addresses will be delivered to all the computers on the local network? - Answers 10.1.240.255/24 Which of the following is a good reason to subnet an IPv4 network? (Choose all that apply.) - Answers Decrease the size of the broadcast domain Conserve IP addresses Which of the following IP addresses has 12 bits in the host ID? - Answers 12.156.109.252/20 You have set up an email server that needs to respond to email requests by using and in the request URL. How can you do this? - Answers Configure two IP addresses on one NIC. Configure DNS to map one IP address to and the other IP address to . You have a server with two NICs, each attached to a different IP network. You're having problems communicating with devices on remote networks that send packets to one of the interfaces. The server receives the packets fine, but the server's replies never reach the intended destination network. Replies to packets that come in through the other interface seem to reach their destination without any problems. What can you do that will most likely solve the problem? - Answers Use the route command to add routes to the networks that aren't receiving replies. You have just changed the IP address on a computer named computer5 in your domain from 172.31.1.10/24 to 172.31.1.110/24. You were communicating with this computer from your workstation with no problems right before you changed the address. Now when you try the