Pubs Exam Questions and Answers 100% Pass

Pubs Exam Questions and Answers 100% Pass FAA certificated mechanics may - approve for return to service a minor alteration they have performed appropriate to the rating(s) they hold. Certificated mechanics with a powerplant rating may perform - 100-hour inspections required by the Federal Aviation Regulations on powerplants, propellers, or any components thereof, and may release the same to service. Refer to Figure 62, 62A, & 62B as necessary.) How many parts will need to be fabricated by the mechanic in the construction and installation of one doubler? - B. 3 Where are technical descriptions of certificated propellers found? - Propeller Type Certificate Data Sheets. Which aircraft record entry is the best description of the replacement of several damaged heli-coils in a casting? - Eight 1/4 -- 20 inch standard heli-coils were replaced. The damaged inserts were extracted, the tapped holes gaged, then new inserts installed, and tangs removed. The action required by an AD may take what form? 1. Inspection. 2. Part(s) replacement. 3. Design modification. 4. Change in operating procedure(s). 2 | P a g e Created by Katelyn Whitman © 2025, All Rights Reserved. 100% PASS GUARANTEE 5. Overall change in the content, form and disposition of aircraft maintenance records. - 1, 2, 3, or 4 Which aircraft record entry best describes a repair of a dent in a tubular steel structure dented at a cluster? - B- Welded a reinforcing plate over the dented area 14 CFR Part 65 Subpart D contains regulations regarding the certification of - C. Mechanic's Who is responsible for upkeep of the required maintenance records for an aircraft? - C—The aircraft owner. A repair, as performed on an airframe, shall mean - the restoration of the airframe to a condition for safe operation after damage or deterioration. 1) The Federal Aviation Regulations require approval after compliance with the data of a Supplemental Type Certificate. (2) An installation of an item manufactured in accordance with the Technical Standard Order system requires no further approval for installation in a particular aircraft. Regarding the above statements, - only 1 is true. Refer to Figure 62.) The -100 in the title block (Area 1) is applicable to which doubler part number(s)? - -101 Why is a mechanic applicant issued a temporary certificate after successful completion of the required tests? - To allow for review of their application and supplementary documents. How long are AD compliance records required to be kept? - They shall be retained, and then transferred with the aircraft when it is sold. How long does the holder of a certificate issued under Part 65 have to notify the FAA after any change in permanent mailing address? - 30 days 3 | P a g e Created by Katelyn Whitman © 2025, All Rights Reserved. 100% PASS GUARANTEE Aviation Maintenance Alerts (formerly General Aviation Airworthiness Alerts) - B—provide information about aircraft problems and suggested corrective actions. For aircraft operated under Part 91, which of the following records must be retained for at least one year, or until the work is repeated or superseded? - Records of maintenance, alterations, preventive maintenance, 100-hour, annual, and progressive inspections. Placards required on an aircraft are specified in - Aircraft Specifications or TCDS 1) A Supplemental Type Certificate (STC) may be issued to more than one applicant for the same design change, providing each applicant shows compliance with the applicable airworthiness requirement. (2) An installation of an item manufactured in accordance with the Technical Standard Order (TSO) system requires no further approval for installation in a particular aircraft. Regarding the above statements, - only 1 is true The replacement of a damaged engine mount with a new identical engine mount purchased from the aircraft manufacturer is considered a - C—minor repair. A person installing a product, part, or appliance on a type certificated product must make certain that the item's records document the - The product, part, or material meets FAA airworthiness standards. The replacement of fabric on fabric-covered parts such as wings, fuselages, s