ABO/NAO 6 QUESTIONS AND ANSWERS WITH
VERIFIED SOLUTIONS 100% CORRECT
if the segment seems too high to the wearer the dispenser might - ANSWER
spread the nose pads apart
polishing the edges of a high minus lens should: - ANSWER be accompanied
with AR coating to decrease internal reflection
if the right temple is angled down, this adjustment will - ANSWER raise the
right side of the front
when fitting progressive addition lenses certain critical measurements are taken.
one of the most important is the: - ANSWER monocular pupillary
measurement
to relieve excessive pressure causing soreness at the back edge of the nose pads, a
good adjustment would be: - ANSWER flare pads out more/ spread back edge
apart more
if there was a height of 24mm for each of the following, which lens shape would
be your last choice? aviator, round, oval, or octagonal - ANSWER aviator
a lens mounting that attaches separate bridge and temples to the lenses typically
with screws or clamps is a: - ANSWER rimless mounting
if the segments seem too high - ANSWER increase pantoscopic tilt
VERIFIED SOLUTIONS 100% CORRECT
if the segment seems too high to the wearer the dispenser might - ANSWER
spread the nose pads apart
polishing the edges of a high minus lens should: - ANSWER be accompanied
with AR coating to decrease internal reflection
if the right temple is angled down, this adjustment will - ANSWER raise the
right side of the front
when fitting progressive addition lenses certain critical measurements are taken.
one of the most important is the: - ANSWER monocular pupillary
measurement
to relieve excessive pressure causing soreness at the back edge of the nose pads, a
good adjustment would be: - ANSWER flare pads out more/ spread back edge
apart more
if there was a height of 24mm for each of the following, which lens shape would
be your last choice? aviator, round, oval, or octagonal - ANSWER aviator
a lens mounting that attaches separate bridge and temples to the lenses typically
with screws or clamps is a: - ANSWER rimless mounting
if the segments seem too high - ANSWER increase pantoscopic tilt
