NCCCO TELESCOPIC BOOM CRANE- SWING CAB(
WITH 100% CORRECT ANSWERS ALREADY
GRADED A+
A crane is operating with a long boom, on outriggers, on uneven ground. Under these
conditions it is important to - ANSWER>>Block under the float or pad to achieve a 90
degree angle between the cylinder rod and the float or pad
What is the purpose of a boom length indicator? - ANSWER>>Indicates the extended
length of boom
According to OSHA 1926 subpart cc, floats/pads must be fastened to the
outrigger/stabilizers when - ANSWER>>They are in use
A crane's jib is offset 15 degrees versus it's original 0 degree offset and the boom angle
remains unchanged, the load radius will - ANSWER>>Increase
When leaving telescopic boom cranes unattended overnight or for longer periods, the
boom should be - ANSWER>>Fully retracted and stowed
On a telescopic boom truck crane that has all 5 outriggers properly positioned, the
working area diagram will indicate the "over front" area is - ANSWER>>Determined by
the crane manufacturer
According to OSHA 1926 subpart cc, who determines if a crane can be used for pick and
carry operations? - ANSWER>>The manufacturer
WITH 100% CORRECT ANSWERS ALREADY
GRADED A+
A crane is operating with a long boom, on outriggers, on uneven ground. Under these
conditions it is important to - ANSWER>>Block under the float or pad to achieve a 90
degree angle between the cylinder rod and the float or pad
What is the purpose of a boom length indicator? - ANSWER>>Indicates the extended
length of boom
According to OSHA 1926 subpart cc, floats/pads must be fastened to the
outrigger/stabilizers when - ANSWER>>They are in use
A crane's jib is offset 15 degrees versus it's original 0 degree offset and the boom angle
remains unchanged, the load radius will - ANSWER>>Increase
When leaving telescopic boom cranes unattended overnight or for longer periods, the
boom should be - ANSWER>>Fully retracted and stowed
On a telescopic boom truck crane that has all 5 outriggers properly positioned, the
working area diagram will indicate the "over front" area is - ANSWER>>Determined by
the crane manufacturer
According to OSHA 1926 subpart cc, who determines if a crane can be used for pick and
carry operations? - ANSWER>>The manufacturer
