J-STD-001E Exam with correct Answers
Hardware characteristics or conditions that do not conform to the requirements of this
specification are classified as ____________ - Answer -Hardware defects or hardware
process indicators.
The __________ always takes precedence over this standard, referenced standards
and drawings. - Answer -contract
When a clause in this document is referenced, - Answer -its subordinate clauses also
apply.
This drawing represents? - Answer -Wire overwrap.
During an audit an employee is found using tobacco products in the work area. this
would be? - Answer -D1D2D3
The IPC-T- 50 document provides _________ - Answer -terms and definitions.
Solder alloys shall be in accordance with J-STD- ____ or equivalent. - Answer -006
A solder connection that appears dull, matte, satin, gray, or grainy and is normal for the
material or process involved is considered? - Answer -Acceptable.
All IPC certification programs for MIT, CIT, and CIS require re-certification after what
period of time? - Answer -2 years.
Component damage that exposes the component substrate or active element or affects
structural integrity is? - Answer -D1D2D3
Any violation of minimum electrical clearance as a result of conformance to defined
criteria is a ______ condition. - Answer -Defect
After cleaning, you observe particulate matter left on the assembly and correctly identify
the condition as _______ - Answer -D1D2D3
When an external flux is used in conjunction with flux cored solders, the fluxes shall be
________ - Answer -compatible.
Hardware characteristics or conditions that do not conform to the requirements of this
specification are classified as ____________ - Answer -Hardware defects or hardware
process indicators.
The __________ always takes precedence over this standard, referenced standards
and drawings. - Answer -contract
When a clause in this document is referenced, - Answer -its subordinate clauses also
apply.
This drawing represents? - Answer -Wire overwrap.
During an audit an employee is found using tobacco products in the work area. this
would be? - Answer -D1D2D3
The IPC-T- 50 document provides _________ - Answer -terms and definitions.
Solder alloys shall be in accordance with J-STD- ____ or equivalent. - Answer -006
A solder connection that appears dull, matte, satin, gray, or grainy and is normal for the
material or process involved is considered? - Answer -Acceptable.
All IPC certification programs for MIT, CIT, and CIS require re-certification after what
period of time? - Answer -2 years.
Component damage that exposes the component substrate or active element or affects
structural integrity is? - Answer -D1D2D3
Any violation of minimum electrical clearance as a result of conformance to defined
criteria is a ______ condition. - Answer -Defect
After cleaning, you observe particulate matter left on the assembly and correctly identify
the condition as _______ - Answer -D1D2D3
When an external flux is used in conjunction with flux cored solders, the fluxes shall be
________ - Answer -compatible.
