PLTW IED Final Exam Review B Questions And Answers With Verified Solutions

The hand-written messages on the fire truck sketch below are examples of ______________. - Annotations What are the part indicators called on this image? - Balloons What is the name of the item pictured below that is sometimes found on a drawing sheet? - Parts List What is the name of the item pictured below that is commonly found on a drawing sheet? - Title Block Never dimension to a(n) - Hidden Line What part below would require a section view for manufacture? - B What tool used during the design process is pictured below? - Design Matrix Circles and arcs that share the same center point are _________________. - Concentric Which figure below contains a multiview drawing that is associated with the given isometric pictorial? - Figure 1 Which figure below represents the most complete and appropriately dimensioned multiview drawing? - Figure 3 ___________ is a type of drawing that is done freehand and without the use of drawing tools. - SketchingIdentify the line type shown below and identified by #32. - Hidden Line In the diagram below, which line type is #34? - Extension Line What type of line is used in an orthographic sketch to represent the edges of the part? - Object line What type of line is used in an orthographic sketch to project the size of an object from one view to another? - Construction Line A leader line is used to dimension - All of these What term best describes the list of items below? Must be made out of 4 to 6 pieces Must be "interlocking" Part cannot extend more than 3 units in any direction No two parts can be the same - Constraints If an entire automobile was modeled as a 3D CAD assembly, which of the following would most likely serve as a subassembly? - An engine If the sweep feature was applied to the shape and path pictured below, which figure would most likely result? - Figure 4 Which figure below could result in the greatest amount of overall width variation if the tolerance for each dimension is ±0.02 inch? - Figure 2During which step of the design process would a design brief be written? - Problem Identification A(n) _______________________ is the most common method of communicating the shape and size of an object that is intended for manufacture. - Multiview Projection All of the icons pictured below represent ______________ constraints and can be used to define the shape and size of sketched geometry in a CAD system. - Geometric