SUAS Final Exam Review 2024 Questions and Answers 100% Pass

SUAS Final Exam Review 2024 Questions and Answers 100% Pass "E" must be set a minimum of _______ meters from "L" and in the proper direction for landing. - Correct Answer ️️ -500 A procedure, practice, or condition, etc. that is essential to emphasize is a what? - Correct Answer ️️ -Note A procedure, practice, or condition, etc. that may damage equipment if not carefully observed or followed is - Correct Answer ️️ -Caution After completing preflight check, if the launch will be significantly delayed, what should the operator do? - Correct Answer ️️ -Remove AV battery and begin again at a more appropriate time Airspace control uses ________________ what? - Correct Answer ️️ -Both positive and procedural control, or a combination of both A procedure, practice, or condition, etc. that may result in injury or death if not carefully observed or followed is - Correct Answer ️️ -Warning A minimum distance of _____ feet between AV and GCS should be maintained to prevent interference with GPS acquisition. - Correct Answer ️️ -6 Always verify the data (location, range, and bearing) is accurate for what waypoints? If these points are inaccurately entered or set outside the range limits of the system (~10 KM); this could induce Loss of Link or cause the loss of an AV - Correct Answer ️️ - "+","H","E", and "L" waypoints At what battery voltage does the AV battery low comes on? - Correct Answer ️️ -21.9 Confirm magnetic heading is + or - _____________ degrees of actual magnetic heading. - Correct Answer ️️ -10 During a non-planned coordination for contingency operations, the SUAS operator will provide what to the appropriate controlling agencies, e.g., FSO, JSOAC, JSOTF? - Correct Answer ️️ -5 - line ACMREQ During launching the AV, maintain climb direction into wind until approximately how many ft AGL before selecting the appropriate flight mode? - Correct Answer ️️ -200 - 300 During preflight checks, on the check throttle step verify the battery voltage is greater than ________ after throttle reaches 100% and waiting 3 seconds. - Correct Answer ️️ -23 volts Ensure boot-up altitude is within _________ of actual altitude - Correct Answer ️️ -50 ft EO Pan and Tilt is available in what mode or operating parameters? - Correct Answer ️️ -Loiter and Circling orbit waypoints Failure to properly seat the tailboom to the fuselage can cause what? - Correct Answer ️️ -Reduced link range and degraded video quality For the LOL Finish Flight feature to function properly, what must occur? - Correct Answer ️️ --Finish flight option selected, AV in NAV mode flying NAV waypoint loop or Orbit; or in HOME mode -Loop Timeout set to a reasonable time -AV loses link or command unchecked for more than 6 seconds For typical landing procedures, it is recommended that Autoland be initiated above _______ AGL - Correct Answer ️️ -75 ft AGL For what size area will the HUB hold DTED - Correct Answer ️️ -50 km x 50 km If Auto Update Waypoint and Rally Altitude are selected in the Config window and Mission Management Screen is used to set up a mission, how are the waypoint and rally altitudes calculated after the Use button is clicked? - Correct Answer ️️ -By the system (Falconview) If AV is not being used regularly, recharge backup battery at least _________. - Correct Answer ️️ -Once a year If GPS fails in LOIT mode or in NAV mode when an orbit waypoint is set as the active waypoint, what is the AV programmed to do and will AV respond to joystick input? - Correct Answer ️️ -Maintain its present altitude and continue the left turn at a constant rate / yes If GPS fails in NAV or HOME mode, what is the AV programed to do and will AV respond to the joystick input? - Correct Answer ️️ -Maintain its present altitude and fly at zero turn rate / yes If the AV enters LOL mode and if GPS fals for longer than __________ the AV will enter __________. - Correct Answer ️️ -30 seconds Autoland In MAN mode, the throttle switch functions are: - Correct Answer ️️ -- Controls motor power directly - Each toggle click changes motor power 5% In the last step of disassembly procedure, the locator is turned off by - Correct Answer ️️ -Changing first digit, then cycling back to previous digit of channel switch It is very important that the propeller be installed with the __________ facing the motor. - Correct Answer ️️ -Yellow paint Raven B DDL systems operating within close proximity should use channel separated by at least _________ channel numbers, to reduce mutu