PA STATE INSPECTION PART 2 TEST QUESTIONS AND ANSWERS

PA STATE INSPECTION PART 2 TEST QUESTIONS AND ANSWERS How should vehicle ownership, legality and proof of financial responsibility be proven? - Answer-By vehicle registration, certificate of title or manufacturers statement of origin What else can be presented for inspection while being held for resale by a dealer licensed to sell vehicles in this Commonwealth? - Answer-A vin-specific auction slip OR VIN specific secure power of attorney (POA) When checking glazing, when should it be rejected? - Answer-When the glass etching extends more than 3 1/2 inches from lowest exposed portion of rear window, rear side window or rear wings. How many inches does the glass etching need to extend to be rejected? - Answer-3 1/2 inches When should the windshield wiper system be rejected? - Answer-If the wipers do not operate as specified by the manufacturer OR 45 cycles per minute if not specified OR Wiper blades are torn or smear/ streak windshield after 5 cycles After how many cycles can windshield wipers smear/streak before being rejected? - Answer-5 cycles How many cycles must the wipers complete in 1 minute to pass? - Answer-45 cycles If the fender flares more than THIS MANY inches then it would be rejected. - Answer-3 inches in width When presented with a vehicle registration card, when do you reject it when comparing to the license plate? - Answer-If the license plate is not in agreement with the numbers on the vehicle registration card. What is the exception when the license plate is not in agreement with the vehicle registration card to still be accepted? - Answer-If ONLY one digit is incorrect or two digits are transposed AND the owner provides evidence that the appropriate department form has been completed to correct this error In term of the VIN plate; when is it to be rejected? - Answer-When the VIN plate is not securely fastened or is defaced, misplaced, or missing. The bumpers are to be rejected if some part of the main horizontal bumper bar on passenger vehicles does not fall within HOW MANY inches above ground level? - Answer-16-20 inches The bumpers are to be rejected if some part of the main horizontal bumper bar on multipurpose passenger vehicles and light trucks does not fall within HOW MANY inches above ground level? - Answer-16-30 inches