1
MK1 swe| 672 QUESTIONS| WITH COMPLETE
SOLUTIONS LATEST 2024
When is the cutter engineering report due? - ANS Jan 31
What type of engine is on a P100 - ANS Single cylinder air cooled four stroke
How long will a P6 pump run on a tank of fuel - ANS 4 hours
What type of engine is on a P6 pump - ANS 6.5 horsepower Honda GX-200 has engine
How would you test 4-20 mA sensor - ANS In series
The MPU - 23 card exhibits what color lights on the panel when operating normally -
ANS Green Yellow Yellow
How many digits are in a NSN - ANS 13
What cut are R/G teeth? - ANS helical
Oil fog out of R/G - ANS Faulty precipitator
Standard hoses shall be identified as Standard in Hose Log and shall be scheduled for
replacement at intervals not to exceed - ANS 8 years
What % hydraulic failure is due to contamination? - ANS 80%
Hoses installed in the weather without an outer covering specifically designed for
service in the weather shall have a service life not to exceed - ANS 5 years
When using an ammeter to troubleshoot a system always use what - ANS The highest
scale
Small engine exhaust hose service life shall be in accordance with the hose
manufacturer recommendation or - ANS 5 years whichever is less
The most common type of media for coarse filtration is - ANS Surface media
What is the disadvantage of a centrifugal pump - ANS Suction lift
The shelf life for hoses and prefabricated hose assemblies shall not exceed - ANS 10
years
As wire size increases, what happens to resistance and amperage? - ANS Resistance
down - Amperage up
P a g e 1 | 35
,2
What does CAN stand for? - ANS Controller Area Network
What % of working pressure do you test a temp hose - ANS 150
How does a rise in the R/O input water temp effect the output temp - ANS Output
increases
What coolant is used in a keel cooler? - ANS antifreeze
At a modernized unit, where is your boat inspection report recorded? - ANS ALMIS
How often is the cutter engineering report conducted - ANS Yearly
Rudder stock is supported by what? - ANS bearing
Waster ring in the sea chest is for what? - ANS prevent galvanic corrosion
What is the acceptable leakage rate in a screw type hydraulic pump shaft seal - ANS
50ml
If you have a bearing failure in a centrifugal pump with excessive vibration, what is the
likely cause? - ANS misalignment
What causes aeration in a hydraulic system if there are no leaks? - ANS low fluid
You find something else is wrong with a piece of equipment already CASREPed what
should you send? - ANS Update
A thrust bearing supports what type of movement - ANS axial and radial
What does SSS stand for in a SSS clutch? - ANS Syncro-Self-Shifting
How is tin measured in a spectrometric oil analysis? - ANS ppm
If you find 40psi in a TANB trailer tire what type of discrepancy is it? - ANS restrictive
Where can DEMPS procedures be found? - ANS NEM-233-11
What type of fuel does a P100 run on - ANS F76 and JP5
When do you have zincs in freshwater - ANS Never
What is considered a hot surface on piping requiring flange shielding for LO - ANS 650
What is considered a hot surface on piping requiring flange shielding for FO - ANS 400
P a g e 2 | 35
,3
What happens to hydraulic oil for every 18 degrees it rises above 140 - ANS Oxidation
rate doubles
What type of o-ring is the most resistant to petroleum products - ANS Buna-S
Before you inflate a shaft seal what must you do first - ANS Stop and lock shaft
After an oil and filter change how many hours of engine operation should be allowed
before sampling - ANS 25 hours
Check amps on a non clamp ammeter - ANS In series
How is the boat record kept in a modernized unit - ANS EAL
What is the max thickening and dilution of L/O - ANS 40% thickening, 5% dilution
Oil intervals on a R/G - ANS 500 hours
what should the chlorine levels on the potable water shore tie be - ANS .02ppm for
15min or .02ppm for 30min
What date is placed on the hose tag - ANS Replacement
Jacket water is tested - ANS monthly
What type of fuel has FSII - ANS F44
what size safety chains are used on an rbs trailer - ANS 1/2"
What PMS does not show up in the Cutter engineering report - ANS Daily and weekly
Wet and dry bulb thermometer determines - ANS Humidity
What is the PSI for a medium service air system - ANS 151 to 1000 psi
Engineering casualty control is concerned with - ANS Prevention minimization and
correction of operational and battle casualties
Excessive property should be reported to - ANS Property officer
Which component can be pressure compensated or non pressured - ANS Flow control
valve
If a CAN buss has 120 ohm resistors at each end what is the total resistance on the
good CAN buss? - ANS 60 ohms
P a g e 3 | 35
, 4
What do you clean a battery terminal with - ANS Sodium Bicarbonate/ Ammonia
Where do you place a plastigauge - ANS Center
What are the 4 parts of a turbine - ANS Compressor, Combustor, Turbine, Auxiliary
What is the flashpoint of F-76? - ANS 140°
Smallest particle visible to the naked eye - ANS 40 microns
What will take hierarchy if manuals conflict - ANS NEM
Max leakage rate on a screw type pump - ANS 50 ml
When building an o ring what is the max stretch for inside diameter - ANS No more
than 10%
What is 1/8 as a decimal? - ANS 0.125
While test running BF225 Honda what is the Minimum voltage - ANS 12 volts
On a TANB Trailer, Tire Pressure below 40PSI - ANS Restrictive discrepancy
On a TANB trailer tire tread depth below 1/8" - ANS Restrictive discrepancy
When do you adjust the gap on an iridium spark plug - ANS Never
How long do you have to reset the DTC with the jumper installed (Honda) - ANS 20
seconds
What RPM does VTECH engage on a BF150 - ANS 4300 RPM
At what RPM does the VTEC Activate on a BF-225 - ANS 4500rpm
When low oil pressure is detected in a Honda what does it do - ANS Returns to idle
What tells you the a boat is safe to run in Almis - ANS Fully Mission Capable
what is a clear and bright test? - ANS Looking for water and sediment
When you increase wire diameter what happen - ANS Decrease resistance and
increase flow
How do you hook up a battery in parallel - ANS Positive to positive and negative to
negative
P a g e 4 | 35
MK1 swe| 672 QUESTIONS| WITH COMPLETE
SOLUTIONS LATEST 2024
When is the cutter engineering report due? - ANS Jan 31
What type of engine is on a P100 - ANS Single cylinder air cooled four stroke
How long will a P6 pump run on a tank of fuel - ANS 4 hours
What type of engine is on a P6 pump - ANS 6.5 horsepower Honda GX-200 has engine
How would you test 4-20 mA sensor - ANS In series
The MPU - 23 card exhibits what color lights on the panel when operating normally -
ANS Green Yellow Yellow
How many digits are in a NSN - ANS 13
What cut are R/G teeth? - ANS helical
Oil fog out of R/G - ANS Faulty precipitator
Standard hoses shall be identified as Standard in Hose Log and shall be scheduled for
replacement at intervals not to exceed - ANS 8 years
What % hydraulic failure is due to contamination? - ANS 80%
Hoses installed in the weather without an outer covering specifically designed for
service in the weather shall have a service life not to exceed - ANS 5 years
When using an ammeter to troubleshoot a system always use what - ANS The highest
scale
Small engine exhaust hose service life shall be in accordance with the hose
manufacturer recommendation or - ANS 5 years whichever is less
The most common type of media for coarse filtration is - ANS Surface media
What is the disadvantage of a centrifugal pump - ANS Suction lift
The shelf life for hoses and prefabricated hose assemblies shall not exceed - ANS 10
years
As wire size increases, what happens to resistance and amperage? - ANS Resistance
down - Amperage up
P a g e 1 | 35
,2
What does CAN stand for? - ANS Controller Area Network
What % of working pressure do you test a temp hose - ANS 150
How does a rise in the R/O input water temp effect the output temp - ANS Output
increases
What coolant is used in a keel cooler? - ANS antifreeze
At a modernized unit, where is your boat inspection report recorded? - ANS ALMIS
How often is the cutter engineering report conducted - ANS Yearly
Rudder stock is supported by what? - ANS bearing
Waster ring in the sea chest is for what? - ANS prevent galvanic corrosion
What is the acceptable leakage rate in a screw type hydraulic pump shaft seal - ANS
50ml
If you have a bearing failure in a centrifugal pump with excessive vibration, what is the
likely cause? - ANS misalignment
What causes aeration in a hydraulic system if there are no leaks? - ANS low fluid
You find something else is wrong with a piece of equipment already CASREPed what
should you send? - ANS Update
A thrust bearing supports what type of movement - ANS axial and radial
What does SSS stand for in a SSS clutch? - ANS Syncro-Self-Shifting
How is tin measured in a spectrometric oil analysis? - ANS ppm
If you find 40psi in a TANB trailer tire what type of discrepancy is it? - ANS restrictive
Where can DEMPS procedures be found? - ANS NEM-233-11
What type of fuel does a P100 run on - ANS F76 and JP5
When do you have zincs in freshwater - ANS Never
What is considered a hot surface on piping requiring flange shielding for LO - ANS 650
What is considered a hot surface on piping requiring flange shielding for FO - ANS 400
P a g e 2 | 35
,3
What happens to hydraulic oil for every 18 degrees it rises above 140 - ANS Oxidation
rate doubles
What type of o-ring is the most resistant to petroleum products - ANS Buna-S
Before you inflate a shaft seal what must you do first - ANS Stop and lock shaft
After an oil and filter change how many hours of engine operation should be allowed
before sampling - ANS 25 hours
Check amps on a non clamp ammeter - ANS In series
How is the boat record kept in a modernized unit - ANS EAL
What is the max thickening and dilution of L/O - ANS 40% thickening, 5% dilution
Oil intervals on a R/G - ANS 500 hours
what should the chlorine levels on the potable water shore tie be - ANS .02ppm for
15min or .02ppm for 30min
What date is placed on the hose tag - ANS Replacement
Jacket water is tested - ANS monthly
What type of fuel has FSII - ANS F44
what size safety chains are used on an rbs trailer - ANS 1/2"
What PMS does not show up in the Cutter engineering report - ANS Daily and weekly
Wet and dry bulb thermometer determines - ANS Humidity
What is the PSI for a medium service air system - ANS 151 to 1000 psi
Engineering casualty control is concerned with - ANS Prevention minimization and
correction of operational and battle casualties
Excessive property should be reported to - ANS Property officer
Which component can be pressure compensated or non pressured - ANS Flow control
valve
If a CAN buss has 120 ohm resistors at each end what is the total resistance on the
good CAN buss? - ANS 60 ohms
P a g e 3 | 35
, 4
What do you clean a battery terminal with - ANS Sodium Bicarbonate/ Ammonia
Where do you place a plastigauge - ANS Center
What are the 4 parts of a turbine - ANS Compressor, Combustor, Turbine, Auxiliary
What is the flashpoint of F-76? - ANS 140°
Smallest particle visible to the naked eye - ANS 40 microns
What will take hierarchy if manuals conflict - ANS NEM
Max leakage rate on a screw type pump - ANS 50 ml
When building an o ring what is the max stretch for inside diameter - ANS No more
than 10%
What is 1/8 as a decimal? - ANS 0.125
While test running BF225 Honda what is the Minimum voltage - ANS 12 volts
On a TANB Trailer, Tire Pressure below 40PSI - ANS Restrictive discrepancy
On a TANB trailer tire tread depth below 1/8" - ANS Restrictive discrepancy
When do you adjust the gap on an iridium spark plug - ANS Never
How long do you have to reset the DTC with the jumper installed (Honda) - ANS 20
seconds
What RPM does VTECH engage on a BF150 - ANS 4300 RPM
At what RPM does the VTEC Activate on a BF-225 - ANS 4500rpm
When low oil pressure is detected in a Honda what does it do - ANS Returns to idle
What tells you the a boat is safe to run in Almis - ANS Fully Mission Capable
what is a clear and bright test? - ANS Looking for water and sediment
When you increase wire diameter what happen - ANS Decrease resistance and
increase flow
How do you hook up a battery in parallel - ANS Positive to positive and negative to
negative
P a g e 4 | 35
