LP Gas Master Qualifier: Gas Installation & Service Latest 2024

LP Gas Master Qualifier: Gas Installation & Service Latest 2024 Where do you find (in which code book) the approved materials to be used in the venting of regulators? Chapter and Section? A. NFPA, 6.10.1.6 B. NFPA 58, 5.10.3.1 C. NFPA 54, 3.3.99.5 D. NFPA 54, 3.3.101 B. NFPA 58, 5.10.3.1 Where do you find which testing needs to be performed in the installation of a new appliance into an existing system? Chapter & Section? A. NFPA 54, 8.2 B. NFPA 58, 12.6 C. NFPA 54 Annex D D. NFPA 54, 10.26 A. NFPA 54, 8.2 After filling a tank in an "Out of Gas" situation what procedures must be followed and where are the procedures found? A. NFPA 58, 6.18 B. NFPA 54, 8.2.3 C. NFPA 58, 6.22.3 D. NFPA 58, 3.3.4.2 B. NFPA 54, 8.2.3 In which code book will you find the approved type of materials for plastic tubing? (tubing joints) A. NFPA 54 Supplement 7 B. NFPA 54, 5.6.8 C. NFPA 58, 7.2.2.7 B. NFPA 54, 5.6.8 In which code book do you find the separation distances of both ASME and DOT tanks from AC units, building openings, and property lines? A. NFPA 58, Supplement 3 B. NFPA 58, Annex L C. NFPA 58, Annex F D. NFPA 58, Annex I D. NFPA 58, Annex I Discuss the difference between a System and Equipment Leakage Test and a System Pressure Test. NFPA 54, 8.1.4-System Pressure Test NFPA 54, 8.2- System Leak Test Discuss May a DOT Cylinder be buried? NO; NFPA 58, 6.8.2.1 What is the maximum depth (below grade) that an AG/UG ASME tank may be installed underground? 12 inches What type of listed or approved Flexible Connectors may be installed through walls, floors, and partitions? None