API 510 Questions and Answers Already Passed

API 510Questions and Answers Already Passed NDE examinations must be scheduled at intervals that consider the Probability of the NDE method to identify the damage What is the transition temperature of a metal? The temp at which the material fracture code changes from ductile to brittle A primary goal of API 510 internal inspection is to Find damage that cannot be found by monitoring external CMLs When conducting a hydrostatic pressure test special attention should be given when testing low alloy steels especially 2 1/4 cr because They may be prone to temper embrittlement What is the maximum chloride concentration allowed for water or steam when hydro testing 300 series 50 ppm For austenitic stainless steel the susceptible temperature range of CUI is 140 degrees and 400 degrees How many systems and procedures must be documented and implemented per API 510 in a owner user inspection repair management system for pressure vessels and pressure relief devices 19 The consequence of a release is dependent on The type and amount of process fluid contained in the equipment The surface at a weld with a joint factor the 1.0 is corroded. The calculation to determine if the thickness at the corroded are governs the allowable working pressure should be The thickness of the surface of the weld includes 1" or twice the minimum thickness on either side of the weld whichever is greater A methodology whereby flaws and conditions contained within an equipment item are assessed in order to determine the integrity of the equipment for continued service is referred to as Fitness for service evaluation What is a pressure vessel engineer responsible for Activities involving design engineering review analysis or evaluation of vessels When can pressure tests of vessel components be performed in lieu of entire vessel testing After consultations with an engineer An inspection plan shall be developed for All pressure vessels and pressure relieving devices Which of the following techniques is specifically cited by API 577 as having special limitations due to concerns for incomplete fusion GMAW -Spray transfer According to API 510 on stream inspections should be conducted by whom An inspector or examiner All tools equipment and personal protective equipment used during vessel work Should be check prior to work Welding inspection occurs Prior to, during, and after welding During welding operations the inspector should