ncc question and answer 2024

UNDERGROUND CABLE FAULT DETECTION USING ARDUINO 1Lata Rai, 2Neha Chikane, 3Rachna Karale, 4Dhananjay Sarfare, 5Prof. Sanket Singhania 1Student, 2Student, 3Student, 4Student, 5Associate Professor 1Electronics & Telecommunication Engineering Department, 1Shivajirao S. Jondhale College Of Engineering, Dombivli (E), India Abstract: In urban areas, electrical cables run underground instead of running over, because it does not affected by any adverse effect of weather such as heavy rainfall, snow, thunder storm. Whenever a fault occurs within the underground cable, it is difficult to detect the exact location of the fault for the repair process of particular cable. The proposed system found the point of the exact location of fault. The paper uses the standard concept of Ohm’s law i.e. when a low dc voltage is applied at the end of feeder through series resister (cable lines) then the current will vary depending on the location of the fault Short in the cable. This system uses an Arduino microcontroller and a rectified power supply. In this case, the current detection circuit in combination with the resister is connected to the microcontroller with the aid of an ADC device to represent the length of wire in Km. Error creation is performed by a set of switches. The relays are controlled by a relay exciter IC, which is used to check cable line. A 16x2 LCD is used to display information. Also one more feature is that using GSM the message of fault detection, location of fault and distance of fault from base station in kilometres this all information is send to base station. As soon as a fault occurs in a cable the buzzer produce the alarm to alert and to take an immediate action by field workers.[1] Key Words — Arduino microcontroller, Ohm’s law, LCD, GSM, ADC, Cable Fault,GPS Module Index Terms Introduction: