ASE A3 Questions and Answers 100% Pass

ASE A3 Questions and Answers 100% Pass Noise: In gear, clutch disengaged (pedal to floor) - Answer ️️ -Pilot bushing or bearing Noise: Neutral, clutch disengaged (pedal to floor) - Answer ️️ -Release bearing Noise: Neutral, clutch engaged (pedal up) - Answer ️️ -Input shaft bearing Binding U-Joint will damage?? - Answer ️️ -Extension housing bushing and seal What is used to check the clearance between the shift fork and the synchronizer sleeve? - Answer ️️ -A feeler guage Warped pressure plates... - Answer ️️ -... should be replaced Ring and pinion gears... - Answer ️️ -...should be replaced as a set What tool is used to measure ring gear runout? - Answer ️️ -A dial guage How many times can a collapsible sleeve be tightened? - Answer ️️ -Once, and must be replaced if over tightened. What tool is used to check pinion bearing preload? - Answer ️️ -Inch pound torque wrench How much vacuum is required to operate a transfer case? - Answer ️️ -15hg What type of bearings require preload? - Answer ️️ -Tapered roller bearings Can a bad speed sensor affect shift pattern? - Answer ️️ -Yes What is a viscous clutch designed for? - Answer ️️ -Compensating for differences in axle rotation What kind of noise will chipped gear teeth make? - Answer ️️ -Growling or grinding noise Bell housing transmission bore and the rear face should be checked for? - Answer ️️ -Runout Check runout before or after installing pressure plate cover? - Answer ️️ -Before Correct face runout by... - Answer ️️ -Installing shims Symptoms of a stuck pilot bearing? - Answer ️️ -Clutch not disengaging Noise