CWB Codes and Standards (Practice Test Questions) Already Graded A

CWB Codes and Standards (Practice Test Questions) Already Graded A The AWS D1.1 Structural Welding Code-Steel includes welding procedure and performance qualification requirements The CSA is one organization accredited by the Standards Council of Canada for developing standards related to joining and inspection. Name another one. Canadian General Standards Board (CGSB) Which Canadian standard includes ferrous and non-ferrous materials with notch toughness and includes aluminum piping systems? CSA Z662 True or false: "Provisions for pre-qualified procedures are included in CSA W59.2 and AWS D1.2 standards/Codes for fabricating aluminum and its alloys". False CSA S473 includes a comprehensive fracture control plan. Most standards are created by: voluntary efforts In Canada, shop inspections of pressure vessels are performed by: an inspector employed by the regulatory authority in the province of fabrication. What are the three main categories of qualified personnel required by CSA W47.1 and CSA W47.2? Welding Engineer, Welding Supervisor, Welder Which of the following codes/standards do not deal with fabrication, but include the qualification of welding procedures and welding personnel? ASME Section IX T/F - AWS D17.1 was developed in part to replace MIL-STD-1595 and MIL-STD-2219. True The function of standards can be said to: Educate, simplify, certify and protect T/F - "Generally the word "shall" in a standard means that the user of the standard is obliged to satisfy the condition". True CSA W59 allows for the use of what materials? carbon steels and low-alloy steels Which code/standard does CSA B51 refer to for the qualification of welding procedures? ASME IX The CAN/CSA Standard N285.6 Series covers the qualification and welding requirements for: thin walled zirconium tubing T/F - CAN/CSA S473 introduces a Fracture Control Plan. True AWS D1.1 does not allow for the pre-qualification of procedures welded with which of the following? GMAW - Short Circuit and ESW T/F - "ASME IX is a design standard." False The area(s) not covered by the ISO is (are) electrical and electronic T/F - The Canadian Council of the International Institute of Welding is a member of the IIW. True