ASE certification Exam 2024

ASE certification Exam 2024 The air pressure at the inlet of the HVLP gun is normally between: A.10-30 psi B.30-50 psi C.50-70 psi D. none of the above - Answer ️️ -B:30-50 psi Painter A says that primer-surfacer will dry faster if sprayed in several coats with flash time between coats. Painter B says there would be less bridging if all the primer surfacer is sprayed on in one operation. Who is right? A. Painter A only B. Painter B only C. Both A and B D. Neither A or B - Answer ️️ -A. Painter A only The door shown above has a large number of paint chips. The paint is the original finish. Painter A says the chips should be filled with an application of polyester glazing putty before refinishing. Painter B says that the chips should be sanded out before refinishing. Who is right? A. Painter A only B. Painter B only C. Both A and B D. Neither A or B - Answer ️️ -C. Both A and B Which of these procedures would help find pits, blisters, and small shrunken impressions on a plastic repaired area after priming? A. blowing and dusting the repaired area B. wire brushing and dusting the repaired area C. block sanding the area with a medium grit paper D. wiping off the repaired area with thinner - Answer ️️ -C. block sanding the area with a medium grit paper Painter A says that if one of the air holes labeled 'A' is blocked with dry paint, it would cause the spray gun pattern shown above. Painter B says that is the on the air holes labeled 'B' is blocked with dry paint, it would cause the spray gun pattern shown above. Who is right? A. Painter A only B. Painter B only C. Both A and B D. Neither A or B - Answer ️️ -A. Painter A onl