Millwright Test Questions with correct Answers 100%

Millwright Test Questions with correct Answers 100% If the seal was not properly aligned or there is excessive wear in some bearing or shaft______ wear tracks will be the indicator. - ANSWER ️️ Unusual For removing hard to remove gasket materials found on sealing surfaces ______ is recommended. - ANSWER ️️ sharpened brass putty knife Apprenticeship training is - ANSWER ️️ Conducted on the job Charting alignment on a graph requires a chart that is divided into thousandths of an inch vertically for the indicator readings and into whole inches horizontally for the _______ measurements. - ANSWER ️️ Distance The orthographic drawing may contain a dash or ______ line - ANSWER ️️ Hidden In order to shoot through a test object and project an image onto a detector sheet or film radiography used as a source of penetrating _____. - ANSWER ️️ Radiation Which of the following task would you not perform with dividers? - ANSWER ️️ Measure angles The overspeed trip device is actuated when the turbine reaches a predetermined limit usually _______ percent above normal full load speed - ANSWER ️️ 10 Positive results in an offset measurement mean that the MTBM is ______ or on the 3 o'clock side - ANSWER ️️ High Coupling gap is set and then there is measured - ANSWER ️️ Offset m