NACE CIP 2 EXAM. QUESTIONS WITH ANSWERS.

Non destructive tests for heat shrink sleeves included Destructive tests for heat shrink sleeves include The following materials can be used to repair FBE Describe common reasons that wood might be painted Non-Ferrous substrates include: Special substrates that have rightly adherent oxide films include Maintenance coating operations are defined as Life cycle of a coating system can be affected by: When determining the coating system life cycle, the following should be considered Maintenance coating selection process should take the following into consideration With regards to maintenance coatings all parties should agree on Feathering What causes curling Some service situations in which permeation may occur include Hot-dip galvanizing The usual galvanized coating consist of three distinct iron-zinc compounds A few safety issues the inspector should know when working around hot dip galvanizing are List the several major stages of the hot dip process Explain the purpose of both caustic cleaning and acid pickling Galvanizing kettle operating temp List some of the common problems which may be noted during the visual inspections of hot dip galvanized items Faying surfaces What are the different methods of thermal spray application? What is the definition of coating survey? Lost some of the primary reasons surveys are performed Outline step in the process for performing a simple coating survey Summarizing the data and ensure they are accurate, factual and correspond to reference / appropriate standards List individuals who may be qualified to perform a coating survey Cathodic disbandment test List some of the specialized test or equipment that may be encountered by the coating inspector, What information should be included when providing samples for a laboratory? What are the two categories of curing and their definitions List some examples of non-convertible coatings What is a polymerization cured coating? List some examples of convertible cured coatings What is the cause of chalking in an epoxy coating? When using solvent borne inorganic zinc, what would one common reason for a failure to cure