ASNT VT Level II Exam QUESTIONS AND ANSWERS WITH COMPLETE SOLUTION 2023

ASNT VT Level II Exam QUESTIONS AND ANSWERS WITH COMPLETE SOLUTION 2023 B. - 1. Per ASNT Section XI, NDE personnel shall be recertified: A. every 5 years by re-examination B. every 3 years by retraining and retesting C. every 3 years based on continuing satisfactory performance D. annually by retraining B. - 2. Per SNT-TC-1A, when an employee leaves his employer: A. his certification automatically transfers to his new employer B. his certification is automatically terminated C. he must take an examination to be certified by the new company D. he may not be certified by the new employer for at least 3 months D. - 3. Per SNT-TC-1A, certification of NDE personnel is the responsibility of the: A. ASME B. manufacturer C. NRC D. employer B. - 4. A variation or interpretation in the normal physical structure or configuration of a part is called a: A. Flaw B. discontinuity C. defect D. fault D. - 5. Indications caused by repeatd loading, bending or by vibrating stresses are called: A. mass hardness B. lamellar testing C. hot tears D. fatigue cracks B. - 6. A group of joining processes which produces coalescence of materials by heating them to a suitable tempertaure and by using filler metal having a liquidus below 450 degree C (840 degree F) and below the solidus of the base metal is called: A. brazing B. soldering C. resistance welding D. arc welding B. - 7. SCC is a synergistic action of: A. steel and cracks B. stress and corrosion C. structure and coatings D. slag and craters C. - 8. Severe grinding cracks appear as: A. wave-like patterns B. widely C. lattice D. deep crevices B. - 9. Grinding cracks are caused by: A. too light of pressure during grinding B. overheating during grinding C. grinding too large of an area D. grinding with very fast motion of the grinder B. - 10. A process that joins two members together by using capillary action to flow the filler material is called: A. soldering if the temperature exceeds 840 degrees F B. brazing if the temperature exceeds 840 degrees F C. resistance welding D. oxy-fuel gas welding C. - 11. A condition that is of such size, shape, type and location that is detrimental to the useful service of the part is called: A. a flaw B. a discontinuity C. a defect D. an indication D. - 12. Mass hardness of a product is caused by improper: A. weld process B. forging C. casting D. heat treatment C. - 13. The use of this symbol on a drawing indicates a: A. flare V weld on both sides B. fillet weld on both sides C. double V-groove weld D. V-groove weld on the other side D. - 14. Unfused chaplets are associated with: A. fo