EGP1501 Assignment 2 Questions

Assignment: 2 (NEW) Due Date: 10 August 2021
Unique ID: See Additional Resources/Submission Portal Module: EGP1501
(Depends on Semester Registration)


Assignment: 2 (NEW) Due Date: 10 August 2021
Unique ID: See Additional Resources/Submission Total Marks: 115
Portal
(Depends on Semester Registration)

Submission Instructions:

 Each drawing should have the following, Title, scale and projection symbol.

 Submissions will be online via your myUNISA course site.

 Make sure your scanned assignment is clear before submission.

 Once complete combine both questions to one PDF file and submit. See video below:

 https://www.youtube.com/watch?v=jHm9j0P4qbM

 Keep a copy of your submission.

 Make sure your final PDF is not a read only file before you submit. Read only files will not be

marked

 Use your own discretion when dimensions are not given or unclear and when discrepancies

occur add a note to substantiate your reasoning

 All dimensions are in millimeters (mm)



Topics:

 Interpreting orthographic views
 Isometric drawing
 Section drawing
 Assembly
 Development




Page 1 of 6

, Assignment: 2 (NEW) Due Date: 10 August 2021
Unique ID: See Additional Resources/Submission Portal Module: EGP1501
(Depends on Semester Registration)


Question 1 (20)

Figure 1 is a machine block drawing shown in First Angle Orthographic Projection (F.A.O.P). Draw an
isometric view of the machine block.




Figure 1




Page 2 of 6