AUMT 1410SEC5 Exam Questions Part 3 Questions with Correct Answers

AUMT 1410SEC5 Exam Questions Part 3 Questions with Correct Answers


Question 1:
Voltage signals are being discussed:
Technician A says that digital cycles can be used to determine the duty cycle of a device.
Technician B says that an analog signal is more easily interpreted by a controller.
Who is correct?
Answer:
A only



Question 2:
Actuators and sensors are being discussed:
Technician A says that a too low current may mean that an actuator or sensor is not functioning
properly. Technician B says that the controller can monitor actuator and sensor operation
electronically.
Who is correct?
Answer:
Both A and B



Question 3:
Technician A says that an A/C volt signal continually goes from low to high to low values.
Technician B says that a D/C volt signal may be yes/on, high/low, or on/off. Who is correct?
Answer:
Both A and B



Question 4:
There are several different names in use for the ABS controller. All of the following names have
been used except:
EBCM ICU BACU CAB
Answer:
c. BACU



Question 5:
While discussing ABS brakes: Technician A says ABS is excellent in directional stability.
Technician B says ABS is excellent in directional control. Who is correct?